The specific units used in agriculture, forestry and plant ecology include the Weight of Thousand Seeds (g), the established abbreviation is WTS.

In general, however, the specific weight of the seed is characteristic of a certain species of plant, it is a "standard". A higher specific weight is profitable especially in difficult habitats and in years of prolonged or repeated stress, because seeds tend to be the more consistent (with low variability).

Bozena Sera

Specific units for seed density are expressed as grams of mass per cc volume.

Higher seed density is associated with greater seed germination and vigor.

As far as vigor testing in crops such as maize and soybean the Iowa State cold test gives an excellent biological test which will reflect the seedlot potential in the cool soil condition which is most problematic.

Importance of Seed Vigor Testing

Vigor testing does not only measure the percentage of viable seed in a sample, it also reflects the ability of those seeds to produce normal seedlings under less than optimum or adverse growing conditions similar to those which may occur in the field. Seeds may be classified as viable in a germination test which provides optimum temperature, moisture and light conditions to the growing seedlings; however, they may not be capable of continuing growth and completing their life cycle under a wide range of field conditions. Generally, seeds start to lose vigor before they lose their ability to germinate; therefore vigor testing is an important practice in seed production programs.

Testing for vigor becomes more important for carryover seeds, especially if seeds were stored under unknown conditions or under unfavorable storage conditions. Seed vigor testing is also used as indicator of the storage potential of a seed lot and in ranking various seed lots with different qualities.

The biological basis of the seed vigor concept

It has been established that the conditions of seed development, maturation, storage and aging influence seed vigor. Seeds developed under moisture stress, nutrient deficiency, extreme temperatures, etc. often result in light, shriveled seed or collectively called poor-vigor seed. Preharvest environment of high humidity and warm temperatures can also cause loss in seed viability and vigor.  Seed mechanical damage, whether induced by harvesting or conditioning equipment, as well as improper storage conditions are among the factors that adversely affect seed vigor. In addition, genetic factors such as hard-seededness, resistance to diseases, and seed chemical composition influence the expression of seed vigor.

Methods of measuring seed vigor

The general strategy of determining seed vigor is to measure some aspects of seed deterioration or weaknesses, which is inversely proportional to seed vigor.

Cold test, accelerated aging test, electric conductivity test, seedling vigor classification, and seedling growth rate are among the tests that are used to measure seed vigor. In addition, the tetrazolium (TZ test) can be used as a vigor test by classifying the pattern of stained seeds into high, medium and low quality. The AOSA Seed Vigor Testing Handbook is a good source of information on seed vigor testing. Below is a brief description for some of the most common seed vigor tests that are used for various crops including corn, soybean, field beans, peas, grasses, vegetable seeds, and other crops.

COLD TEST (CT)

📷The cold test simulates early spring field conditions by germinating the seeds in wet soils (»70% water holding capacity) and incubating them at 5-10°C/41-51°F for a specified period. At the end of the cold period, the test is transferred to a favorable temperature for germination (e.g., 25°C/77°F in case of sweet corn). The percentage of normal seedlings is considered as an indication of seed vigor. Vigorous seeds germinate better under cold environments.

When can the cold test be used?

ACCELERATED AGING TEST (AAT)

The principle of this test is to stress seeds with high temperatures of (40-45°C/130-139°F) and near 100% relative humidity (RH) for varying lengths of time, depending on the kind of seeds, after which a germination test is made. High vigor seeds are expected to tolerate high temperatures and humidity and retain their capability to produce normal seedlings in the germination test.

When can the AAT test be used?

ELECTRIC CONDUCTIVITY TEST

📷This test measures the integrity of cell membranes, which is correlated with seed vigor. It is well established that this test is useful for garden beans and peas. It has been also reported that the conductivity test results are significantly correlated with field emergence for corn, and soybean. As seeds lose vigor, nutrients exude from their membranes, and so low quality seeds leak electrolytes such as amino acids, organic acids while high quality seeds contains their nutrients within well structured membranes. Therefore, seeds with higher conductivity measurement are indication of low quality seeds as vice versa.

SEEDLING VIGOR CLASSIFICATION TEST (SVCT)

This vigor test is an expansion of the standard germination test (SGT). The normal seedlings obtained from the SGT results are further classified into ‘strong’ and ‘weak’ categories. This test has been used for corn, garden beans, soybean, cotton, peanuts and other crops.

The principle of the test

Seedlings have four significant morphological sites for evaluating vigor:

In this test, seedlings are classified as ‘strong’ if the above four areas are well developed and free from defects, which is indication of satisfactory performance over a wide range of field conditions. On the other hand, normal seedlings with some deficiencies such as missing part of the root, one cotyledon missing, hypocotyl with breaks, lesions, necrosis, twisting, or curling are classified as ‘weak’.

📷

REFERENCES

AOSA. 2009. Seed Vigor Testing Handbook. Contribution No. 32 to the Handbook on Seed Testing.

Elias, S. G., and L. O. Copeland. 1997. Evaluation of seed vigor tests for canola. Seed Technol. 19(1) 78-87.

Kim, S. H., Z. R. Choe, J. H. Kang, L. O. Copeland, and S. G. Elias. 1994. Multiple seed vigor indices to predict field emergence and performance of barley. Seed Sci. &Technol., 22:59-68.

Weight of 1000 number of seeds of a crop is called 'test weight'. I think specific weight is related to weight of a fixed volume of seeds.

Specific weight indicates the density (mass per unit volume). For example, 1ml of water = 1 g. So the specific weight of water is 1 (1g /1ml) and is the reference point. In case of seeds, the completely matured and healthy seeds generally have high specific weight and vigor.

@Rajender Kumar Sharma fully agree

In case of seed, generally test weight of 1000 seeds weight is used as a quality parameter. However, specific weight of any substance is defined as weight per unit volume of that substance. Thus, specific weight may be described as seed weight per unit volume, and it can indicate if the seed is either well filled or chaffy.