What are the thermal properties values of thermal conductivity, specific heat for Jute ?
Murlidhar,
I suspect that c, and k are strongly affected by moisture content. So, for what it's worth:
http://jute.org/composition.html
Note the thermal properties are listed without stating the moisture content.
You may want to have some samples actually measured to deduce practical values.
Thank you very much Dr James Garry ..it is very useful information for me
Put your sample in a DSC and examine it. It will take 30 min only if you run 10 or 20C/min.
If you do not send me.
Dear Friends, kindly help me for this topic so that i will not miss important information which can be useful for future students, as i have to deliver a guest lecture on this topic at my junior...
02 March 2016 1,799 8 View
02 March 2016 2,064 11 View
Can anybody suggest what is the correlation for turbulent heat transfer coefficient for water ?
02 March 2016 4,303 0 View
Dear Friends, I have to deliver a small lecture on this theme please add your comments and help to not miss any points
02 March 2016 8,140 0 View
Dear Friends, If you know about GMP for food additives please suggest me? Regards, Murli
11 December 2015 5,667 0 View
I was seeing many application of MEMS in medical field. Can we use them for food also. If anybody working in this subject, kindly guide me.
07 August 2014 4,495 0 View
If a conference proceedings publication have IMPACT FACTOR, is it valid for several years or it is not valid?
01 January 1970 8,781 1 View
03 March 2021 8,272 1 View
Anyone can recommend any books on such topics? Thanks in advance.
02 March 2021 8,457 2 View
If the detection range is in ng/ml but the reference range is in ug/ml for a molecule or protein in serum or plasma .how to dilute and what is the initial volume to be taken for quantitative analysis
02 March 2021 7,670 3 View
In some materials, properties such as band gap, thermal conductivity differ along different crystallographic axes. What are the basics?
01 March 2021 1,923 3 View
Increased heat, drought and insect outbreaks, all associated to climate change, have increased wildfires. Decreasing water supplies, declined agricultural yields, health impacts in cities owing to...
01 March 2021 7,168 9 View
Should I mesh the solid domain ? or should I use wall thickness? or Shell conduction? for Heat Transfer between two fluids of a Heat Exchanger. what is recommended?
01 March 2021 9,785 3 View
I want to cool Natural Gas from 195 Kelvin to 138 Klevin in a heat exchanger by using liquid nitrogen as the coolant medium. When entering the heat exchanger, the liquid nitrogen will have a...
01 March 2021 6,450 5 View
I have been trying to simulate heat transfer problem in Comsol 5.5 for long time but it always throw an error stating: "Failed to find a solution. Maximum number of Newton iterations...
28 February 2021 8,626 3 View
Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.
28 February 2021 3,640 3 View
Hi Guys. I'm a mechanical engineer and have a bit trouble, would be very glad if you could help me with my questions. I have a pressurized tank which contains Natural Gas at 200 Bar and 293...
26 February 2021 6,253 3 View