What are the limitations of additive manufacturing?

More Indrasen Bhattacharya's questions See All

What are some theoretical bounds on a data-driven image classification method?

Consider a simple problem such as cat-classification.. what are some parameters on which an upper bound on accuracy would be expected to depend? Empirical human accuracy is of course a good metric...

08 September 2019 9,436 7 View

What are some of the limitations of radiation therapy?

In particular, what are the resolution limits of radiation planning as applied to cancer therapy? Do these limits depend only on the equipment, or are we starting to see some limitations due to...

06 July 2017 6,266 2 View

Which is the most convenient manufacturing software for Additive Manufacturing?

Which tools can be used to generate machine codes for additive manufacturing?

02 March 2021 7,220 2 View

What software programs can directly simulate Additive Manufacturing Directed Energy Deposition (DED)?

I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....

24 February 2021 4,428 3 View

How to differentiate the economic productivity in agriculture and in manufacturing sector?

Most of the references I found were on the economic productivity in agriculture but very limited application in manufacturing sector. I would appreciate if anyone could share the references on...

15 February 2021 8,342 7 View

How to remove unedited version of the manuscripts from research gate?

Our manuscript was published ahead of print. The edited and revised version is now available. How do I remove the old version of the manuscript from the research gate?

01 February 2021 5,965 1 View

How could I do a simulation for the energy consumption of a CNC machine?

I'm working on my dissertation and it is about how to save energy when a CNC machine goes to idle mode. (A concept model of the idle machine energy saving in industrial manufacturing...

26 January 2021 9,620 5 View

How to add a single parameter in Ansys Additive Manufacturing Workbench parameter setting dialogue box?

Ansys 19.2 R2 and 2020 R1 versions of Additive Manufacturing Workbench is convenient for powder-based Additive Manufacturing processing. However, in this workbench, there is a machine parameter...

19 January 2021 3,017 2 View

How to give port for printed log periodic dipole array antenna in CST?

PLPDA have radiating element on both sides of the substrate. so how to apply port. i have attached the figure below.

03 January 2021 4,005 6 View

What is your expert opinion/experience/suggestion about the new variant of Novel Corona Virus (COVID-19)?

Dear Research Gate Members, Nowadays, everyone is talking about the new variant of Corona virus COVID-19 and its affects are alarming throughout the world. Please, share your expert suggestions...

29 December 2020 7,555 20 View

Have you observed the improvements in Online Meeting Platforms during COVID-19? In this context, how will you compare Google ZOOM & Microsoft TEAMS?

Dear Research Gate Members, Online Education / Distance Learning and Work From Home (WFH) are the ultimate new realities for many in the world due to Pandemic Novel Corona Virus (COVID-19)...

29 December 2020 9,866 37 View

Hello everyone, which software is preferable for simulating the effect of shrinkage of metal powders for the Additive manufacturing process?

Last time I was asked about simulation software to analyze the effect of shrinkages of plastic powder materials. Currently, an additive manufacturing process is what I find suitable for my...

29 December 2020 4,615 9 View

Indrasen Bhattacharya

Hi Peter,

Thanks for the abstract, I'm also interested in any journal articles or reviews. Additionally, I'm interested in limitations that are fundamental - due to topology, material and other such constraints. Any leads on those would also be really appreciated.

Regards,

Jean Luc Maire

Advantages and disadvantages of additive manufacturing in:

https://fr.scribd.com/document/265699855/Advantages-and-Disadvantages-of-AM