Typical application for a specific microstructure.
Typical application would be woodcutting tools [1]. I also heard about safety belt fasteners [2], but I don't know, how typical application it is.
[1] R.K. Mozberg, Materials Engineering. "Vysshaya shkola", Moscow, 1991 (in Russian).
[2] K. Jaason, P. Peetsalu, M. Saarna, P. Kulu, J. Beilmann, Decarburization effect on hardened strip steel fastening components. Mat. Sci. (Medzd.), 2016, 22(1), 148-152.
For any evaluation, what would be the suitable citation counter?
01 February 2014 4,328 3 View
What is a friendly tool to quantify 3D shape factor for a particle?
01 February 2014 2,148 1 View
Hello everyone. Given microstructure image belongs to a 12% ledeburitic cold work tool steel (annealed and tempered). The sample was etched with picral (100 mL ethanol and 4 g picric acid). I...
02 March 2021 4,119 3 View
Which solution reveals the microstructure and features of nickel-based alloys?
02 March 2021 2,221 3 View
Which tools can be used to generate machine codes for additive manufacturing?
02 March 2021 7,220 2 View
I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....
24 February 2021 4,428 3 View
Most of the references I found were on the economic productivity in agriculture but very limited application in manufacturing sector. I would appreciate if anyone could share the references on...
15 February 2021 8,342 7 View
Hi, Hope you can help. Currently been running some sandwich ELISA assays where I coat with anti-His, block and then capture His-tag protein and then sera and then anti-bovine monoclonal...
07 February 2021 7,101 1 View
Hi everyone, I am looking for fluorescence expression vectors for expression in gram-positive bacteria present in the skin microbiome. I need to tag them with a fluorescence marker and observe...
06 February 2021 2,566 4 View
I'm working on my dissertation and it is about how to save energy when a CNC machine goes to idle mode. (A concept model of the idle machine energy saving in industrial manufacturing...
26 January 2021 9,620 5 View
I have tried using acetic picral and 5% nital solution when observing the microstructure of severely deformed pure magnesium. Unfortunately, I keep getting similar microstructures (as shown below)...
20 January 2021 8,783 4 View
Ansys 19.2 R2 and 2020 R1 versions of Additive Manufacturing Workbench is convenient for powder-based Additive Manufacturing processing. However, in this workbench, there is a machine parameter...
19 January 2021 3,017 2 View