Typical count rate for laser based XUV source?

06 June 2018 1 5K Report

What is the typical count rate for a velocity map imaging spectrometer used with laser based XUV source when a rare gas target e.g. Xenon is used.

Rajib Biswas

Some relevant links are attached for your ready reference.

a) https://www.osapublishing.org/josab/viewmedia.cfm?uri=josab-15-10-2620&seq.

b) https://aip.scitation.org/doi/am-pdf/10.1063/1.4939759

c) https://arxiv.org/pdf/1509.01311

d) https://arxiv.org/pdf/1602.03703

e) www.nat.vu.nl/~wimu/Publications/XUV-handbook.pdf

Badges
Science topic

More Mamuna Anwar's questions See All

Low count rate in velocity map imaging?

I am using velocity map imaging (VMI) for analyzing the electrons generated by soft x-ray beam. The target gas is Neon and is injected through a thin capillary, I get pressure of 1.3 E-4 mbar in...

01 January 1970 2,455 3 View

Using OBD technique i am trying to measure laser induced shockwaves velocity i found that at start velocity increases and then decay?

i am unable to interpret why its increases in start as shown in figure

11 August 2024 2,179 1 View

Can you connect an HPLC to a Mass Spec only at a certain time point?

Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...

11 August 2024 8,141 3 View

Hello researchers Is this a random laser or just fluorescence?

I am using Rhodamine6G as gain medium and silver nanoparticles as scatterers on a microscope slide and laser input 532 nm comes from above.

09 August 2024 9,894 2 View

GC-MS retention index prediticon?

Hello experts, Does anyone know any free software about retention index prediction ?

08 August 2024 7,403 2 View

AUX gas reading problem on QE with full MS and PRM method in one run?

Dear QE-users, In the method where full MS positive mode and PRM mode are used, we always get an incorrect auxiliary gas reading (41 instead of 25). This only happens in this method; other...

06 August 2024 4,953 0 View

Absorption coefficient of methane?

Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?

06 August 2024 980 5 View

How can I inoculate a lyophilized anaerobic bacteria into the culture medium without an anaerobic chamber?

There are anaerobic gas pak jars and environment providers in the laboratory that provide anaerobic environmental conditions for the growth of anaerobic bacteria. However, there is no anaerobic...

05 August 2024 4,945 3 View

Could dyes amplify the spectrum of light to a specific wavelength?

I am interested to know the behavior of dyes toward light. Specifically, Blue dyes re-emit the spectrum, especially from the green zone (known as principal in LED lamps, and blue dyes are known...

05 August 2024 3,290 1 View

Is there any Indian Company or Startups, from any universiy or IITS, which manufacture Gas Chromatography instrument , i want to make a custOmized G?

or we can collaborate

01 August 2024 6,705 2 View

Gas chromatography RT detection?

I am working on algal extract to which gas chromatography (Not GC-MS) spectrum I want to discover. My question is can we identify specific compounds using retention time if I compared the RT with...

29 July 2024 8,034 4 View