Does the pressure(-600 mmHg) affects pH?

When I conducted the degassing experiment using decompression under anaerobic condition(and I used ferrous based chelating agent), the oxidized ferric were observerd. So, could you tell me the...

03 March 2021 4,892 5 View

How can we raise the figure when we writing a paper with Latex ?

Hi, everyone. I'm a starter to write a paper by Latex. But I have some difficulty using it. I'm writing the paper with 2 columns. And, there is one figure that occupies the 2 both-sides. I want to...

26 February 2021 3,738 3 View

Satellite orbit estimation using Recurrent Neural Network - what should I use?

Hello, I am a master's student studying in Yonsei Univeristy, Korea. I am trying to estimate the state of satellite, using Neural Network. Below is a simple flow of my study. 1. Train (t0 ~ t1)...

23 February 2021 6,383 3 View

What is the system of units used in the thermal conductivity by Spitzer and Harm?

23 February 2021 9,253 1 View

How many days do we need to detect adoptively transferred Treg in the tumor site in tumor-bearing recipient mice?

Hello, I've got a plan to isolate mouse splenic Treg (WT and KO of target gene) and inject these CD45.2 Treg into tumor-bearing CD45.1 mice. My question is how many days do I need to wait to see...

11 February 2021 8,238 1 View

Is it possible to antibody labeling with FITC cause antibody disfuction?

Hello, I studied how much bound my test antibodies to the target antigen using FITC labeling to test antibodies. I tested 3 types of antibodies, the elisa binding affinity and cytotoxicity...

07 February 2021 8,335 2 View

Can you use MTS assay with cells cultured in media containing phenol red?

I am trying to run a cell viability assay with LN229, but these cells are cultured in DMEM which contain phenol red. Is the MTS assay sensitive to the additional of phenol red in the media? If so,...

03 February 2021 9,478 2 View

Lighting for open field test behavior assay?

I am currently setting up our lab's behavioral space to run the open field test in rats, and I am trying to figure out how to set up lighting to evenly illuminate the open field chamber (a 90 cm x...

26 January 2021 1,399 3 View

Is there a surface inactive water-soluble dye?

Hi guys, I'm looking for a water-soluble dye which is not surface inactive in order to observe (water in oil) emulsions; I don't prefer to use oil-soluble dyes. I've used rhodamin123,...

21 January 2021 8,496 2 View

Can I calculate the average from the data which are collected every 30 minutes for ANOVA?

I artifically elevated the air temperature in the heated plot by 3-celsius degree compared to that in the control for 7 days. I want to figure out the effect of the temperature manipulation on...

21 January 2021 1,185 8 View

How much pressure we can reduce at the outlet to avoid Reverse Flow?

I am simulating Heat Exchanger. I have tried and tested all the methods to resolve this issue from the internet like refining mesh, improving skewness and orthogonal quality ,extending outlet to...

01 March 2021 6,985 3 View

What test should I use to compare two or three means, if data is not normally distributed but sample size is > 30 in each group?

I personally feel this as a most confusing question. As per my understanding, if sample size is > 30, and sample is skewed, we can still use paramteric approach, as it will follow Z...

01 March 2021 1,587 6 View

How to increase mesh quality of a cfd model in ansys fluent?

How can one improve mesh skewness, orthogonality, aspect ratio?

28 February 2021 7,730 3 View

How to find a correlation between coordinates in a curvilinear coordinate system?

Hello. I have a skewed elliptical coordinate system (I use alternative elliptical coordinates). And I need to determine connections between coordinates in order to fetch a covariance matrix of...

28 February 2021 364 3 View

Why is my CFD problem (mini heat sink rectangular channel) not converging while having good quality mesh?

My CFD problem is having two interconnected rectangular channel, which is known as mini heat sink. I have already performed parallel flow inside of an interconnected mini heat sink. However, I...

19 February 2021 3,209 3 View

How to compare means of continuous data with zero-inflation and skew?

I have two groups (unpaired) of plant biomass measurements and want to know whether there is a test that can be used to determine statistical significance where assumptions are not violated. The...

18 February 2021 1,258 4 View

T-test and Mann-Whitney U test on groups with different sample sizes and variances?

Hello I have 2 groups with different sample sizes of (experts: 5 to 8) and (Users: 28 to 35) answering 21 questions on a 7 points Likert scale about the importance of some dimensions for...

31 January 2021 3,885 7 View

How do you incorporate a study that used non-parametric analysis into a meta-analysis where majority of studies used parametric?

I am calculating Hedge's g for effect sizes, so I am pulling means, SDs, and Ns, from each study. However, one study did a Mann-Whitney U test, and so reports Mean Rank, Sum of Ranks, U, Z, and r...

31 January 2021 1,182 5 View

Is there any packages or code of MATLAB for solving a system of stochastic delay differential equation?

Hello, Can you help me regarding MATLAB solver for a system of stochastic delay differential equations? To be specific the system is delay differential equation where parametric stochasticity is...

15 January 2021 6,950 7 View

Data Normality test in SPSS and Mardia's web of power to check skewness and kurtosis online test?

When we check our data set for univariate (e.g., SPSS) and Multivariate Skewness and Kurtosis as measures of non-normality as defined by Mardia (via Mardia' s web of Power) in order to...

12 January 2021 8,257 5 View