I have this problem the following error message appeared to me

Elements to be separated by cohesive elements are of more than one stiffness number (169 and 172, perhaps more). The CZMESH command is ignored

I am trying to modeling  the debonding between concrete and CFRP using 2D analysis. in order to present the debonding I have to use the CZM with contact element. how could I solve this problem could you help me?

after generating the target element and the contact element iused the following command

TB,CZM,3,1,1,CBDD

TBDATA,1,C1,C2,C3,C4,C5,C6   ( HERE I PUT THE VALUES THAT I CALCULATED FOR (C1,C2,...)

R,1

RMODIF,1,3,-1E6

RMODIF,1,12,-1E6

CZMESH,CM_1,CM_2

after that the error message appear how could I solve this problem (the attached photograph show the model with error message. any answer ?

Similar questions and discussions