Sir,my question is bleaching the papers pulp before manufactured tea bags and for pesting edges used plastic coatingthis is good are bad for human ?

Vinod Verma @Vinod_Verma7

03 March 2018 1 8K Report

For research purpose.

Emmanuel Vijayanand Murray

There is no doubt that these are harmful and should be avoided and substituted by safer methods.

Badges
Science topic

Similar topics
Econ
Manufacturing

Which is the most convenient manufacturing software for Additive Manufacturing?

Which tools can be used to generate machine codes for additive manufacturing?

02 March 2021 7,220 2 View

What software programs can directly simulate Additive Manufacturing Directed Energy Deposition (DED)?

I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....

24 February 2021 4,428 3 View

Steps to calculate activation energy by coats & redfern method?

I'm a chemistry student and I'm researching the kinetic degradation of mixed plastic waste. I'm having trouble calculating the activation energy by the coats & Redfern method. The data that...

24 February 2021 974 1 View

Droplet PCR in plastic chips always result an unexpected band, any suggestion of possible contaminations and how to improve?

I am doing droplet based digital PCR inside plastic chips. I can get the correct band, but I also consistently get an unexpected band, slightly shorter. I attached a typical gel image here....

18 February 2021 6,618 2 View

How to differentiate the economic productivity in agriculture and in manufacturing sector?

Most of the references I found were on the economic productivity in agriculture but very limited application in manufacturing sector. I would appreciate if anyone could share the references on...

15 February 2021 8,342 7 View

Inquiry regarding engineering journals for free publications for my dissertation (laser polishing of 3D printed parts?

my dissertation was on laser polishing of 3D printed plastic parts, i want to publish it, can anyone suggest me a free copy engineer journal for this purpos, plz?

01 February 2021 7,140 4 View

How could I do a simulation for the energy consumption of a CNC machine?

I'm working on my dissertation and it is about how to save energy when a CNC machine goes to idle mode. (A concept model of the idle machine energy saving in industrial manufacturing...

26 January 2021 9,620 5 View

How to measure the hardness for PLA & PHAs polymers?

Hello, I am a bit confused on whether to follow ASTM D785 (Standard Test Method for Rockwell Hardness of Plastics and Electrical Insulating Materials) or ASTM D2240 (Standard Test Method for...

21 January 2021 7,487 4 View

Is there a way to get rid of TEA in a TLC plate in order to do proper staining?

Dear colleagues: I have been trying to establish a few HP-TLC methods in the lab. In general, for quantification purposes, I prefer CuSO4+acid charring, to primuline staining. Lately I have been...

20 January 2021 9,019 1 View

How to add a single parameter in Ansys Additive Manufacturing Workbench parameter setting dialogue box?

Ansys 19.2 R2 and 2020 R1 versions of Additive Manufacturing Workbench is convenient for powder-based Additive Manufacturing processing. However, in this workbench, there is a machine parameter...

19 January 2021 3,017 2 View