Simpower library, you can find many blocs....

Hello Aditya Purkar ,

First can you define what parameters/variables you wish to model? What is the objective of the model?

As a starting point there are a lot of single-phase machines modelled in MATLAB/Simulink that you can inspect:

https://www.mathworks.com/help/physmod/sps/powersys/ref/singlephaseinductionmotordrive.html

https://www.mathworks.com/help/physmod/sps/powersys/ref/singlephaseasynchronousmachine.html

https://www.mathworks.com/help/physmod/sps/examples/ac9-single-phase-induction-motor-drive.html

https://www.researchgate.net/post/How_can_I_simulate_a_single_phase_induction_generator_in_Matlab_Simulink

https://www.mathworks.com/help/physmod/sps/motors-and-generators.html

In Matlab you can go to simulink then depending on your parameters you can select any block required from Simpower library.

Thank you for the help,

I want to use single phase alternator to charge automotive battery and for this simulation, I am new to electrical circuits in automobiles actually.. unable to decide if such system is even feasible with single phase charger also couldn't find such an alternator in simscape/simulink. Could you please help on this?

Regards.

It is better to use the equivalent circuit of the Single phase electric generator, in this case the simple simulation blocks i.e. resistance, coil...etc, will be sufficient.