19 September 2013 1 6K Report

With gas chromatography the concentrations of some impurities are already determined. In addition how can the UV absorbance at 240 nm during UV-Vis Spectroscopy or other methods be used to determine the concentrations of the remaining unidentified components in pharmaceutical grade ethanol?

More Sadananda Konchady's questions See All
What are the reasons for exhibiting highest ductility at 650°C in PM Nickel base superalloy EP741NP?

tensile rest was carried out at different temperature starting from room temperature to 850°C. it is observed that yield strength and ultimate tensile strength remain unaffected until 650°C...

25 March 2021 1,280 2 View

Can you help me for generating chicken swarm optimization matlab code?

Multi-objective optimization through chicken swarm optimization technique. Both maximization and minimization problem.

31 December 2020 2,604 4 View

New ASTM standard for fatigue crack growth thresholds

Fatigue or cyclic loads require two load parameters for unambiguous description. Under SN fatigue this expresses as Load Ratio or mean stress effects, illustrated by Goodman et al more than 100...

01 January 1970 2,651 2 View

Similar questions and discussions
Which type of compound does lamda max of 218 indicate in a uv-vis spectrum of a partially purified compound through column and TLC?

A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...

11 August 2024 9,801 2 View

Can you connect an HPLC to a Mass Spec only at a certain time point?

Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...

11 August 2024 8,141 3 View

Baseline drift in HPLC? What causes this?

Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!

11 August 2024 3,770 4 View

GC-MS retention index prediticon?

Hello experts, Does anyone know any free software about retention index prediction ?

08 August 2024 7,403 2 View

Can I use a HisTRAP column for affinity chromatography?

I'm working on selecting antibodies against a recombinant protein that has a His-tag. My idea is to first bind the recombinant protein to a HisTRAP column and then use this column for an affinity...

07 August 2024 505 3 View

AUX gas reading problem on QE with full MS and PRM method in one run?

Dear QE-users, In the method where full MS positive mode and PRM mode are used, we always get an incorrect auxiliary gas reading (41 instead of 25). This only happens in this method; other...

06 August 2024 4,953 0 View

Absorption coefficient of methane?

Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?

06 August 2024 980 5 View

How can I inoculate a lyophilized anaerobic bacteria into the culture medium without an anaerobic chamber?

There are anaerobic gas pak jars and environment providers in the laboratory that provide anaerobic environmental conditions for the growth of anaerobic bacteria. However, there is no anaerobic...

05 August 2024 4,945 3 View

Why might the impedance values for DI water and 0.1X PBS buffer solution exhibit a decreasing and increasing trend, respectively over time (HP 4194A)?

Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...

05 August 2024 3,783 2 View

Why is TLC not a form of partition chromatography?

Why is TLC not a form of partition chromatography and paper chromatography not a form of  absorption chromatography?

03 August 2024 7,035 3 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close