Hello,

I am actually working on the Degree of Conversion of dental resin composites in my lab.

When I perform my FTIR analyses, I apply the equation to calculate the DC (the equation is not wrong, I have already checked that) and I always obtain some values turning around 6% for the best polymerized resin. However my curves appear to be good and the peaks are the same than everybody in the literature (1608cm-1 and 1638cm-1).

You can find in the attached file an example of the curves (red non polymerized, blue polymerized). Sorry if the legend is not in the good order.

Did anybody already have such a problem with the calculations and do you know how to change it ?

Thank you so much

Best regards

More Thibault Canceill's questions See All
Similar questions and discussions