Necking restricts the overall useful forming of a material or component?

22 April 2022 0 9K Report

Necking restricts the overall useful forming of a material or component, and FLC is used for the purpose. What is the necessity to evaluate the fracture strain using FFLD, when FLC is sufficient?

Badges
Science topic

Similar topics
Journal Impact Factor

More Praveen Kumar's questions See All

When was the sheet deformation stopped to identify and distinguish between necking and fracture, ?

When was the sheet deformation stopped to identify and distinguish between necking and fracture, considering the fact that evaluation of plane strain situation is practically not possible in...

12 May 2022 7,357 0 View

Can we eliminate the stress singularity at the tip of the crack by manipulating the elastic constants?

The aim of the research here is to prevent the propagation of the crack in the fabricated elastic medium with useful applications.

25 July 2024 9,976 3 View

Is there a good macro photography kit for on-site metallurgical investigation?

I am looking to purchase a photography kit for onsite metallurgical investigations, such as capturing photos of worn areas, hot tears, cold tears etc. Could anyone suggest me a good...

22 July 2024 3,490 2 View

Consequences of excess bases in the MCS after digestion?

Good morning, I am trying to produce a recombinant protein. Unfortunately I one of the two restriction enzymes that I use do not cut at the end of the MCS. After the digestion 15 nucleotides of...

17 July 2024 2,787 4 View

Hello friends In simulating the drug with the liposome, which side of the liposome membrane is the drug placed on? The top leaf or the other?

Several times by placing a restriction on the upper part of the membrane with the aim of preventing the drug from being added from this side, we tried to keep the drug at the top of the leaf, but...

29 June 2024 9,688 1 View

Can I premix the reagent for restriction digestion and make a mastermix like PCR?

Hi everyone, I am currently trouble shooting my restriction digestion, so far it hasnt given me clear bands when I ran gel. I've been adding all reagents minus template, to make a master mix...

24 June 2024 1,171 3 View

Can cross-slip, twinning and fracture systems, under applied loadings, receive the same mathematical theory?

Cross-slip, twinning and fracture are major deformation modes adopted by loaded materials. It appears sound that these apparently different deformation mechanisms can be analysed on the equal manner!

15 June 2024 8,477 3 View

Will this 3C Analysis work or are the fragments too small/close together?

I'm doing a 3C analysis shown in the picture linked and attached below with the Bait fragments labeled and the target fragments that will be tested for interaction with the bait labeled with...

02 June 2024 8,038 1 View

How to indentify the pre-cracking force in FCGR testing?

Hello all, I need to pre-crack a steel specimen with the following dimensions. W = 25mm, an = 6mm, B = 5mm How do I identify the force required for the pre-crack initiation?

30 May 2024 1,285 2 View

How KAM value are relates with FCGR?

"How will it affect the material? Is a higher KAM value beneficial for restricting cracks, or is a lower value more effective?"

30 May 2024 9,211 0 View

How to scale up or down a restriction enzyme reaction?

Hi I am trying to set up the reactions with my plasmid, insert and RE. Usually the standard final volume is 20 uL or 50 uL (it depends on the protocol provided by the manufacturer) with 1 ug of...

28 May 2024 1,105 3 View