Hello everyone, i have calculated some result in a square cavity, which is available in MATLAB figure. I need four zoomed figure from this single figure. So i have zoomed that part which is required and saved that four figures into different MATLAB files. Now i have a matlab code which combines all four figures into a single figure which contains 2*2 sublpots.
The problem is that when i run the program original figure comes in all four subplots. but in that subplot i zoomed the figure the required zoomed figure (which was saved in separate file) does not obtained.
Any suggestion please
Hi,
The screenshots of your image/s would have been helpful. If your variable is an image then the simplest solution that I suggest is using imtool to obtain the (x,y) coordinates of the portions that you need zoomed and just plot those regions. e.g. if variable 'a' is your complete 2D image and you need to display only a certain portion of that image, say from (1,1) to (200,200) then just use imshow(a(1:200,1:200))
You can use subimage to display multiple images.
Hope this helps
Ruchit G Shah, Hauke Gravenkamp thanks for your suggestions.
I think we can use axis limit to get that required zoomed portion in a figure.
so we can draw my required zoomed area and save in figure.
- Badges
- Science topic
- Similar topics
- Filing