I have attached a file which  is helpful to someone following this question.  Thanks everyone for taking interest

Muhammad,

Well, heat capacities will be around 500 J/kg/K.

So that is 500,000 J/ton/K

Equally, conductivity values for steels are about 40W/m/K

So that's 0.04W/mm/K

(just simple SI manipulation)

Thanks James. I was assuming we have to change J to Nmm and W to Nmm/sec as given in LS-DYNA consistent unit. 

http://www.dynasupport.com/howtos/general/consistent-units

Can you please advice? Thanks

I have attached a file which  is helpful to someone following this question.  Thanks everyone for taking interest

Muhammed,

Yup.

So 1J becomes 0.001 Nmm and so on.