Hi,
I am running a turbine. When solution reach to about 300-400 iteration, I stop run and then i save. but when i again continue run, i have the following error! Why does this happen?
I am grateful that guide me about this case.
Use this forum cfd.oline it can help you. Good luck
Which is the license do you have? Student, Academic or Commercial?
Hi Ali Sam,
This message appears once you run a simulation with larger number of nodes than 512k using Teaching license. You need to ensure that before you run the simulation there is at least one research license free. This happens when there is many users working at the same time using floating licenses.
The other solution is to change the mesh for your case to be under the limit of 512k nodes, but since you have 2 million nodes at the moment it may be a problem.
Good luck.
Damian
- Badges
- Science topic
- Similar topics
- Engineering
- Mechanical Engineering