Is there any simulator for an ARM Cortex-M3 microcontroller? and What is the software?
There are two arm cortex m vhdl files available for free. However they are not for m3. You can download them and simulate the Arch or buy xilinx kit. Here where you can start
https://hackaday.com/2018/10/02/free-arm-cores-for-xilinx-fpgas/
Thank to Mohammad zakaria Masoud for answering the question
Do you think all articles accepted in journals with the highest impact factor are excellent articles?
10 November 2019 5,135 9 View
the questions ask about your favorite. Do you think these questions may reveal your privacy?
09 October 2019 4,160 19 View
Is it possible to be a journal indexed SCI and is not indexed in Scopus?
08 September 2019 8,519 7 View
What is your opinion on the internationalization of university study?
07 August 2019 1,864 4 View
What is the formal website that is used for testing IoT application vulnerabilities?
06 July 2019 1,529 4 View
Is it possible to implement ECC bilinear pairing in WSN?
06 July 2019 9,651 6 View
Is cybersecurity the future of computer science?
06 July 2019 3,850 3 View
What are the differences between multidisciplinary publisher and multidisciplinary journal?
06 July 2019 2,632 3 View
What is the best job position for a Ph.D. ? the teaching or research and development)
06 July 2019 3,425 9 View
Which security proof is better reduction in mathematical or automatic verification by using tools?
06 July 2019 9,513 1 View
Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...
01 March 2021 9,332 6 View
Hello researchers, Hello Castalia3.2 researchers I am a beginner with Castalia, I work on optimization of RFID systems used in wireless body networks. I simulated a WBAN with 10 nodes and one...
28 February 2021 400 1 View
Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks
24 February 2021 9,378 3 View
Hi everyone, I am currently running a mixed-mode simulation of a DCB using a user-defined cohesive zone model (UEL), however, the results I am getting don't make sense. I used the same UEL for...
24 February 2021 4,157 1 View
I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....
24 February 2021 4,428 3 View
Using GDB, it is straightforward to debug and monitor a target program by setting a break-point at a specific instruction, since the instruction addresses are known. However, we have two...
24 February 2021 1,598 2 View
Hi, We are trying to simulate particles with Langevin dynamics in a shear flow by Lees-Edwards boundary conditions in MD simulations. It seems thermal forces and shear flow do not go hand in...
23 February 2021 1,761 1 View
Dear researchers, I want to simulate a flow (air) in a wind tunnel, and I want to integrate a fluidic actuator inside it in order to control the separation of the boundary layer. At the blower...
22 February 2021 4,882 3 View
For my research, I would like to simulate an end to end 5G network. My goal is to observe the behaviour of SDAP protocol, dynamic configuration of 5QI values etc. To summarize I would like to...
21 February 2021 7,624 3 View
Dear Research Gaters, Let me first add context to the question. I am looking to simulate the waste management system and resources of a city. The hardware devices I need to simulate include,...
21 February 2021 2,333 4 View