Is there any method available to plot sand, silt, clay and gravel, all four together in a single plot like soil textural triplot ?

09 July 2020 1 2K Report

My question is related to soil textural plot or classification.

Is there any way to plot all these four constituents together in a single classification plot?

On a classic 2D triplot you cannot (e.g. see the classifications of Shepard, Folk, etc.). You may use a 3D triplot, like a tetramesh.

Badges
Science topic

Similar topics
Engineering
Modeling

More Nikhilesh Singh's questions See All

Please explain how the plastic input value should be considered from the true stress-strain curve for the bilinear elastoplastic material model ?

I am working on Abaqus/Explicit(Quasistatic ) for the deformation of the auxetic structure model. Please explain how the plastic input value should be considered from the true stress-strain curve...

05 August 2024 454 3 View

How to increase citation in Research Gate?

How to enhanced h-index in Research Gate?

04 August 2024 3,368 4 View

How to do wavelet transform of EXAFS data?

I want to do wavelet transform of some compounds for their comparative study? Kindly help me in this regard and provide with proper procedure.

31 July 2024 4,170 0 View

Following click reaction in cell lysates, protein is immobile and remains at the top of the gel in SDS-PAGE?

I am using CuBr/THPTA for a click reaction in total cell lysates. I am facing issues with my protein sample in non-reducing SDS-PAGE where it's not migrating properly and most of it remains at the...

29 July 2024 950 4 View

How to use energy flexibility in inventory modeling?

29 July 2024 2,192 5 View

I want to get updates regarding international law, international trade law, international institutions and human rights etc?

Please send me updates regarding the above-mentioned areas in the question mark?

28 July 2024 5,197 3 View

What is the principle/mechanism behind aging of carbon (graphite) containing refractory mix for isostatically pressed refractories?

The resin bonded carbon containing refractories are aged before use. How time of aging is determined? And mechanism behind aging.

23 July 2024 3,205 0 View

How to remove cell debris after tissue dissociation?

I'm facing issues with the tumor dissociation protocol for GBM. I use collagenase/dispase with DNase to dissociate my tumor sample. However, even after incubating it for 60mins, I do not get a...

22 July 2024 412 3 View

What methods can be used to minimize environmental variability in breeding trial ?

In breeding trials, environmental variability can significantly affect the results, making it challenging to accurately evaluate the performance of different lines and hybrids.

22 July 2024 3,961 4 View

Is profit margin a good variable to measure the market power of a company?

I have read papers where markup has been taken to measure market power. However, if markup data is unavailable, is it okay to continue with profit margin, as when a company has market power, it...

22 July 2024 707 1 View

Is the black sediment consider as sand? If not, how can I filter it out?

Hi researchers! I'm working on soil texture analysis, and the end result for sand is doubtful because there is black sediment appearing after drying, as shown in the figure. Is it considered sand?...

30 July 2024 557 2 View

Why practical assessments of dislocation density by XRD ignores the texture which apparently affects the result?

As one can read in numerous papers on this matter, the dislocation density is derived from the dependence of peak broadening on the diffraction angle, that is, on considered reflections. Thus, to...

28 July 2024 6,496 5 View

How can I calculate spin texture using Quantum Espresso for non-colinear case ?

I want to calculate the spin texture for the electronic band structure obtained from SOC calculation. Is there any way for calculation of spin texture using quantum espresso??

19 July 2024 8,571 1 View

Which/who is the best laboratory/researcher that can provide syntethised mixed-layer clays?

Hi all, I am looking for some syntethised samples of mixed-layer clays to perform infrared reflectance spectroscopy measurements in the VNIR-SWIR-MWIR-LWIR regions. Best regards, Lionel Fonteneau

01 July 2024 3,875 2 View

How to Differentiate Tuffaceous Matrix from Clay Matrix in Sandstone Thin Sections?

I am conducting a study on sandstone samples and need to accurately differentiate between tuffaceous matrix and clay matrix when examining thin sections under a polarized light microscope. While...

20 June 2024 3,270 0 View

Alternative to Centrifuge software (Krumm, 1996)?

Dear colleagues, does anyone know of a suitable alternative for Centrifuge software (calculating settling time for grain size separation by centrifugation), preferably one running on Windows 10 or...

17 June 2024 7,085 0 View

Are there environmental clues from sediment texture?

05 June 2024 2,855 1 View

Dear friends, can anyone help me identify this strange specimen?

This barrel or vase-shaped stony structure was found in the Cretaceous shales. Its outer surface was surrounded by loose and thick limonitic and clayey sheets before I removed them. After...

04 June 2024 5,914 5 View

How to import group of balls in PFC 2D by Itasca?

I have xyz and name of the group of each megapixel from image of rock sample. How can Import these groups as balls into PFC 2 D in order to represent exact the same texture of the rock from image?

29 May 2024 5,940 0 View

Can Soil Texture be changed with organic manures and biofertilizer?

Application of organic manures and biofertilizer only

24 May 2024 8,825 10 View