Which is the most convenient manufacturing software for Additive Manufacturing?

Which tools can be used to generate machine codes for additive manufacturing?

02 March 2021 7,220 2 View

Heat exchanger with liquid Nitrogen as coolant?

I want to cool Natural Gas from 195 Kelvin to 138 Klevin in a heat exchanger by using liquid nitrogen as the coolant medium. When entering the heat exchanger, the liquid nitrogen will have a...

01 March 2021 6,450 5 View

No amplification data for qPCR on MxPro?

I have set up a qPCR run on MxPro with SYBR green and ROX as a reference, however, when I go to the analysis section the program seems to only collect data for the dissociation curves and not the...

25 February 2021 8,039 1 View

What software programs can directly simulate Additive Manufacturing Directed Energy Deposition (DED)?

I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....

24 February 2021 4,428 3 View

IF troubleshooting: looking at an intracellular protein that localizes to the cell's and how to reduce increase in signal due to cell ruffles?

I am currently trying to stain for PI3KBeta in MDA-MB-231 cells. My current issue is that 1) beta stains all over the cell and 2) there is an increase in signal at the edge of the cell and this...

24 February 2021 8,582 1 View

How to get/count refractive index in gasses?

20 February 2021 8,202 6 View

How to differentiate the economic productivity in agriculture and in manufacturing sector?

Most of the references I found were on the economic productivity in agriculture but very limited application in manufacturing sector. I would appreciate if anyone could share the references on...

15 February 2021 8,342 7 View

How to measure 50uL of cells?

Hello, I am planning to do a transformation, and on the protocol it says "Scrape a 50 ml volume of yeast from the YPAD plate using a sterile inoculating loop or sterile toothpick". But I can...

14 February 2021 6,247 3 View

Troubleshooting with immunofluoresence/confocal microscope? What went wrong?

Hi guys, I have no experience and little knowledge on immunofluorescence and confocal microscopy. I tried to visualize the expression of FXR in my cells (THP-1 macrophages), yet I did not...

11 February 2021 562 6 View

Cause of slow bromophenol blue migration and smearing while running SDS PAGE?

While running gels for western blotting, I am currently getting, what seems to be, the blue dye from my sample buffer migrating more slowly in sample lanes leaving blue streaks. These transfer to...

08 February 2021 5,317 3 View