(For example: (Li2B4O7) and other materials
The following book is good to read for this subject
“optical precesses in semiconductors”
by J I Pankove
Hope the attached article helps you.
https://www.sciencedirect.com/science/article/pii/S0921883117304260
Rohini Singh Ahmed Y. Yassin
Thank you for your answers. But I'm looking for a complete reference explaining the band of semiconductors. The above answers are specific examples.
what is the reasons of this changes?
11 December 2019 1,047 5 View
for example In the carbon nanotubes decorated with metal nanoparticles, can guess or calculate the approximate value of metal from the peak intensity ratio?
10 November 2017 4,090 4 View
FOR EXAMPLE CAF2:C , Al2O3:C.....
06 July 2016 5,971 3 View
31 December 2015 7,494 0 View
How to use the photoluminescence cerveto estimate the band gap of materials?
31 December 2015 9,681 2 View
E (NANO) = E (BULK) + ...........
31 December 2015 4,094 2 View
In some materials, properties such as band gap, thermal conductivity differ along different crystallographic axes. What are the basics?
01 March 2021 1,923 3 View
25 February 2021 5,713 1 View
It is a general practice to introduce Ground Plane in FDSOI devices under the BoX. The Ground Planes are introduced by Ion Implantation through Top Si layer and Buried Oxide. I wanted to know that...
24 February 2021 5,974 4 View
Does the absorption coefficient of the semiconductor changes with the change in the structure of the semiconductor? If you have a thin film and nanowire of the same semiconductor, will the...
23 February 2021 9,799 4 View
I have a direct band gap material and an indirect band gap material. If I made a composite of both through physical mixing. Then how can I determine the band gap of such a material as the Tauc...
17 February 2021 8,104 4 View
I am attaching my design and result of Gains.S11 parameter is less than -10dB from 3.1 to 9.8 Ghz.Z11 magnitude also lies between 40 -60 ohm for this range .Still gain is negative. Pls help
29 January 2021 4,334 3 View
In order to enhance the antenna parameters, meta-material unit cells are added but where to load them is more advantageous either at ground plane or at the patch side, also is it necessary to add...
24 January 2021 2,999 4 View
I am looking some resist strippers which can easily remove metal based polymer residue after post dry etch process. I have some candidates below but not sure if they are compatible with doped...
21 January 2021 3,008 3 View
I have tried BoltzTrap, and EPW but I'm not sure whether Boltzmann Transport Equation is a right approach for a complex system (semi cond. + an Oxide layer or even the semiconductor itself). Also...
11 January 2021 4,597 4 View
The observed bandgaps are 3.8 eV and 3.4 eV for spin-coated and electrospun films, respectively. What are the possible reasons?
08 January 2021 5,646 6 View