Is Nano or Micro-Diamond Attracted to Magnets?
If the diamond is synthetic and contains the Ni catalyst remnant in the center, then it is quite conceivable that a high power magnet would be able to exert some influence. I've been able to move Ni wire structures with magnets before. See attached.
Thank you for this valuable information.
Iman Ismael Jabbar Be aware that the information may not be correct.
I agree with Alan F Rawle
Thank you so much Dr. Moaid K Hussain
Did you see Red Color Carbon Nanotubes
01 January 1970 6,181 4 View
I anwar by adsorption or reaction ..but it is either more method...
02 March 2021 4,811 2 View
I took measurements of different concentrations of 15 nm and 5 nm Au nano particle solutions. I'm trying to determine which concentration I measured gives the best reading overall. I also...
02 March 2021 7,626 1 View
Good day to all, I have no experience with light emitting diodes. I am building a glass mini flume to demonstrate the photo degradation of Methylene Blue in water running over self cleaning...
26 February 2021 4,026 5 View
In the formation of Zno nano particles process, after drying at 120 degree C, my zno nano particles are completely white but when i calcine it for 450 degree C it converts into grey colour. i...
26 February 2021 2,435 4 View
I want to remove PDMS oligomers from the surface of nanolayers. I have just read a very helpful paper about the compatibility of PDMS with different solvents( Solvent Compatibility of...
24 February 2021 7,845 5 View
We own a small cPCR thermal cycler from Roche, Lightcycler Nano, which is convenient for backup quick runs. Recently, Roche has discontinued the plastics for it and they offer no alternative from...
17 February 2021 8,694 5 View
I have chemically synthesized silver nanoparticle to combat microbes on wound site. I have used many methods of synthesis, but I found minimal field of silver NP product.I am getting whitish...
11 February 2021 4,964 13 View
Dear colleagues. How can we implement the kinetics of the polymerization of aromatic amines in easier and simpler ways? Are there simpler methods for Nano polymers (other than those obtained with...
09 February 2021 5,783 3 View
Hello everyone! Is a normal value 295.8 ug/ul for cDNA? If not what does it mean? Where is the mistake? The measurement was done with nano drop. Thank you!
09 February 2021 6,202 1 View
I am adding 0.1wt percent MWCNT to glass fiber epoxy composite and want to determine the volume fraction of the MWCNT from this composite but I don't know how to calculate it. can anyone help me...
09 February 2021 8,883 3 View