is JBotSim a simulator of IoT ? if so, what are the routing protocoles already simulated by it ?
you can see this link one:
http://eudl.eu/doi/10.4108/eai.24-8-2015.2261067
Thanks Mr Khalid.
drawing graphs
07 August 2016 2,154 11 View
Best free journal
07 August 2016 789 5 View
i m doing simulation RPL using cooja, and i want to calculate the remaing energy of each nodes after finishing simulation. in fact i want to calculate the life time of nodes and i found that the...
07 August 2016 5,006 14 View
One of the key design principles of RPL protocol is minimizing the routing control overhead and signaling data as a mechanism to reduce energy consumption and even enhance the reliability of the...
04 May 2016 2,053 2 View
Hi All, ETX is calculated based on the packet delivery ratio of forward (denoted df) and reverse direction (denoted dr) of a link, i.e. ETX = 1/(df x dr). df, dr are determined by counting...
04 May 2016 429 1 View
I'm targeting to deploy a mesh network and manually configure MANET routing protocols. I'm preparing scenarios, architectures, and hard devices needed to do that. Are there some step-by-step...
03 March 2021 1,931 5 View
Is there a powerful system for the security of the systems distributed on IoT systems?
02 March 2021 3,858 10 View
The Lanthanide contraction which is the decrease in ionic radii of the elements in the lanthanide series from atomic number 57, lanthanum, to 71, lutetium, is due to poor shielding of the 4f...
01 March 2021 2,272 4 View
Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...
01 March 2021 9,332 6 View
Hello researchers, Hello Castalia3.2 researchers I am a beginner with Castalia, I work on optimization of RFID systems used in wireless body networks. I simulated a WBAN with 10 nodes and one...
28 February 2021 400 1 View
I am working on developing a micromechanical FE model for predicting kink-band formation in UD composites. To model matrix plasticity, which model, out of Concrete Damaged Plasticity and...
28 February 2021 5,415 1 View
I am working on TiO2 composite material and the results of XRD have a lot of small/junk peaks and while I apply a smooth filter in Origin then the other characteristics peaks disappear so anyone...
26 February 2021 8,183 3 View
Hi, everyone I'm working on a privacy-preserving algorithm that will apply to IoT devices. So, I need to measure the power consumption by implementing this algorithm. Any suggestion, advice,...
25 February 2021 8,749 6 View
Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks
24 February 2021 9,378 3 View
Im looking for any papers, reports,articles, links etc on information on How vulnerable is water and wastewater infrastructure to cyber terrorism in an age of IoT.
24 February 2021 2,750 4 View