Is it possible to connect Spartan FPGA with Simulink?

More Yousaf H. Khattak's questions See All

Which software is best for the modeling of tandem solar cells?

I used SCAPS software for modeling and analyzing the performance of a solar cell. For the modeling of tandem solar cells, more than seven layers exclusive of back and front contacts are required....

04 May 2019 1,146 7 View

How to model the battery pack in PSIM or PSCAD?

Hello, I have simulated a single battery cell using Thevenin equivalent circuit. For a battery pack, I have a large number of cells connected in series and parallel connections. Is there any way...

28 February 2021 2,116 1 View

How to find the right number of integration points in second order 3d finite elements?

I am familiar with finite element simulations and numerical schemes like the Gauss Legendre quadrature. I also know that the Gauss integration yields exact values for polynomials up to degree 2n-1...

27 February 2021 6,818 3 View

High aspect ratio hexahedral mesh optimization solver?

I am interested in evaluating mesh optimization solvers that converge to high aspect ratio unstructured hexahedral grids. In other words, I am interested in a solver that optimizes warpage,...

26 February 2021 7,279 2 View

How does an AC-DC power supply Flyback Converter Based USB Charger Model using Matlab/Simulink looks like?

I am required to learn about Flyback converters and I got stuck not knowing to full design of the power supply flyback converter Based USB Charger Model using Simulink, especially the design model...

25 February 2021 5,435 2 View

Anyone with some Transgenomic Wavemaker software? Seeking help from the chromatography community?

I am trying to seek out some Transgenomic Wavemaker software (happy to purchase a computer too) to operate a fraction collector. The only way to connect to the fraction collector so far is to...

23 February 2021 9,181 1 View

How to validate regridding results of environemental data to higher spatial resolution in R?

I am working with several continous, environmental marine datasets at varying original spatial resolutions. My aim is to regrid each dataset to one common, high resolution grid. I am currently...

22 February 2021 2,290 2 View

How to build fouling and erosion simulation model for Aero Engine compressor and turbine rotor in Simulink / Matlab?

22 February 2021 3,697 1 View

How can I get "Matlab/Simulink model for Droop/Reverse Droop controllers"?

Dear Professors, Colleagues and Friends I need to develop a simple Matlab/Simulink model of reverse droop controller for a simple LV MG. How can I get a simple one to use it as a sample? A basic...

22 February 2021 8,647 2 View

The Role of Town Planners in CAV Use?

Colleagues and I are about to begin a project investigating the role of town planners and local authorities in establishing the introduction of connected and autonomous vehicles (CAVs). What...

21 February 2021 2,247 3 View

Why are the modelled and circuit system different in response for controlled buck converter?

[Images are attached at bottom] I am currently working on a buck converter controlled by two different control methods, Reinforcement learning applied to find PID values & a lead-lag...

16 February 2021 5,060 10 View

Krishna Prakash Natarajan

It is possible to connect FPGA boards with MATLAB Simulink. FPGA-in-the-loop (FIL) simulation in Simulink supports this. You can send data from Simulink or MATLAB to the FPGA and receive data from the FPGA.

Check this link:

https://www.mathworks.com/help/supportpkg/xilinxfpgaboards/fpga-in-the-loop-simulation.html

Yousaf H. Khattak

Thank you krishna.

Its really very helpful