Hello,
I am looking for grid-connected PV inverter and battery inverter controllers to implement on TI F28335 control card. Typhoon already provides some examples (.out file) for the controllers, but they are specifically built for f2808 control cards. I would be thankful if someone would provide me with a simulink or ".out" file of the PV and battery inverter controller (either single phase or 3 phase).
Regards,
Hooman
Hello
watch the two videos I prepared for some colleagues in which I help them on their first use of Typhoon and F28335.
https://www.youtube.com/watch?v=xN2lKevmL8c&t=670s
https://www.youtube.com/watch?v=4LqrmCR1khs
It is about a buck converter, but you can easily implement your inverter.
Best Regards
Prof. Tiago
Dear Tiago,
Thanks very much. I am looking for the control stage itself. I have the power stage inside typhoon and just need the control part. I would prefer to have that inside simulink or at least an .out file. Your videos were helpful though.
Best regards,
Hooman
Hello Hooman,
I forgot to tell you that you will find controller for grid connected inverter in this webinar: https://info.typhoon-hil.com/recorded-webinar-rapid-control-prototyping-a-thorough-tutorial-of-rcp-for-3-phase-inverter-controller-design
Code is generated using PSIM.
Dear Hooman
I see. If you want a .out file just to test the communication bewteen the DSP 28335 and the Typhoon HIL, I can send to you.
However, if you want a .out file that runs into the DSP and you expect to see good waveforms of your power structure, then you request is quite hard.
I suggest you to watch webinar of Typhoon as suggested by our colleague Gagrica.
Generating code for F28835 using Simulink is quite harder than using PSIM. You need to study carefully the registers of the DSP to set the 28335 in smiulink. Using PSIM is more friendly. That's my opinion.
Best Regards
Prof. Tiago
Dear Ognjen and Tiago,
Thanks so much for your help. I tried to run Ognjen's file with typhoon-HIL. First, I generated the c code inside PSIM and then opened the project inside CCS. Now I have a new problem. CCS cannot generate the .out file. (no .out file is generated inside "ramdebug" folder in the project directory. I have proceeded based on the tutorial, and the only difference between my project and the tutorial is that there is a missing "rts2800_fpu32_fast_supplement.lib" file in my project (project explorer). But this library still exists in (properties-->c2000 linker-->file search path). So I can't figure out why the .out file cannot be built. (The figure is attached.)
Regards
Dear Hooman.
Let me try to help you.
First of all, what version of PSIM and CCS are you using?
Did you install the "Tidcs". This is a setup from Texas Instruments.
See in your C: path if there is a folder named Tidcs.
Let's keeping talking.
Regards
Prof. Tiago
Dear Tiago,
My PSIM version is 12.0.1 and CCS version is 7 and I did not find any "Tidcs" folder in my computer.
Regards,
H
- Badges
- Science topic
- Similar topics
- Filing