A- due to collision heat is generated?
B- as solute gets extracted in solvent, dissolved gas is released?
Many thanks in advance! Also kindly suggest standard book or peer reviewed article for this question?
For the said problem, extraction might be exothermic in nature which can be verified with some thermodynamic studies.
Please refer to section 3.5- Effect of temperature
Article The extraction of Cr (VI) from aqueous solution with a mixtu...
Hello researchers! I have prepared ZnO and Zn0.98Pd0.02O by sol-gel method. Increase in BET surface area was observed on substitution. What could be the probable reason for increase in SA? Can...
05 June 2017 970 3 View
Hello, I am currently having problems with RNA extraction. I am using mouse liver (C57BL6J), and I have extracted RNA from mouse liver before. Before this experiment, my final RNA pellets were...
11 August 2024 7,082 3 View
I've been performing RNA extraction on cotton petiole tissue for a few months now using the method described in the following paper, a derivative of the typical hot borate method...
08 August 2024 9,882 2 View
I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...
07 August 2024 1,028 0 View
I need to do some experiment with it in liquid form.
07 August 2024 613 3 View
Hi! So i attempted to understand a novel protein behavior towards heat application by analyzing its secondary structure change. I subjected the protein to a thermal denaturation analysis using...
06 August 2024 1,989 3 View
is there any other way to heat a polymer evenly other than oil bath if so what are those and how to use it
06 August 2024 947 1 View
I am having an issue with my gel image where my PCR product is not appearing very bright on the gel. When I perform gel extraction, the A260/280 purity value is very low. I used the Qiagen gel...
05 August 2024 9,798 3 View
Hello everyone I am looking for one or some books for propertes and behaviors of stochastic fibre orientation composites. unfotunately I could not find any suitable reference for thias by...
04 August 2024 3,461 3 View
I will be with my students collecting seaweed samples in a marine farm and later we will process this tissue for RNA isolation and further sequencing. Does anyone have tips on how to collect the...
04 August 2024 501 2 View
I want to Estimate surface heat fluxes using MyLake, but I don't have all the initial values in model parameters section and other sections,is there a way?
04 August 2024 1,537 1 View