In simulink Matlab, how can one do the convolution of two square signals?

Ali Alrawi @Ali_Alrawi

03 March 2013 0 600 Report

For example y=[ 5 5 5 -5 -5 -5 5 5 -5 -5 5 -5 5 5 5 5 -5-5]

for k=1:length(y)

h(k)=y(k)*y(k-1)

end

Badges
Science topic

More Ali Alrawi's questions See All

Faults in High Power Transmission Line?

Dear ColleaguesIn the case of any fault in High Power Transmission Line may lead to fire breakout that consequently results into loss of property, loss of life and destruction of a power system...

01 February 2017 8,646 0 View

What are the most important steps that must be taken by the Engineer during the design of any electrical circuit?

31 December 2015 7,071 0 View

Who can run scilab in matlab?

what is the best way?

11 December 2015 6,874 1 View

How does an AC-DC power supply Flyback Converter Based USB Charger Model using Matlab/Simulink looks like?

I am required to learn about Flyback converters and I got stuck not knowing to full design of the power supply flyback converter Based USB Charger Model using Simulink, especially the design model...

25 February 2021 5,435 2 View

How to build fouling and erosion simulation model for Aero Engine compressor and turbine rotor in Simulink / Matlab?

22 February 2021 3,697 1 View

How can I get "Matlab/Simulink model for Droop/Reverse Droop controllers"?

Dear Professors, Colleagues and Friends I need to develop a simple Matlab/Simulink model of reverse droop controller for a simple LV MG. How can I get a simple one to use it as a sample? A basic...

22 February 2021 8,647 2 View

Why are the modelled and circuit system different in response for controlled buck converter?

[Images are attached at bottom] I am currently working on a buck converter controlled by two different control methods, Reinforcement learning applied to find PID values & a lead-lag...

16 February 2021 5,060 10 View

What's support me on Simulink Matlab Model of Regenerative Braking in DC Traction ?

I have a thesis on Utilize the electrical power from Regenerative Braking in 750 Vdc Traction by simulation in the Program MATLAB Simulink. I made the Power Load flow from 24kV to Traction...

08 February 2021 2,532 1 View

Can we simulate light with matlab ?

Hi, I have to design a digital model of different types of lighting. Is it possible to simulate the lighting level from different sources (LED, incandescent, mainly fluorescence) with matlab...

28 January 2021 3,818 10 View

Algebraic Loop Problem in PV array Solution?

I am doing a project with PV array in Simulink. When I run small section of the total system i do not get an error. But when i integrate full system(my system model`s are completely okay) I get an...

18 January 2021 685 10 View

How to build aero engine fuel system online prognostics simulation model using Matlab, Simulink and Simscape?

17 January 2021 5,181 1 View

"The following block is not supported in Phasor simulation?

I am designing a control system for Hybrid renewable energy systems using Matlab/simulink/simscape, but currently having a problem. Whenever I run the simulation, I get the error shown below. "The...

12 January 2021 2,142 5 View

Steps for Hardware Implementation of Max Log MAP Decoder simulated in MATLAB?

How to implement max Log MAP algorithm turbo decoder on FPGA? Simulation is done on MATLAB. What are the next steps to be followed? Do I need to use HDL Coder feature in MATLAB? Is it needed to...

07 January 2021 4,405 4 View