Dear Sudhir Kumar, without more Details to the product, the materials, your facilities and the Chosen manufacturing process sequence it is impossible to provide any suitable answer. Please provide some Information e.g. product by product.
Best regards, R. Rentsch
When people need to make a few parts of different products the best option may be machining or layer by layer manufacturing.
But obviously, I agree with Mr Rentsch, for a better answer we need more information.
without the details of the products its impossible, you can choose machining process as a cheapest way
http://web.mit.edu/ebm/www/Publications/MEWP_Res_Cons_Recycl_2011.pdf
Hello
Naturally, the best route between casting and plastic deformation is plastic deformation. This is due to the possibility of obtaining quality products after some of the processes of plastic deformation (sheet punching, deep drawing, stamping, rolling, etc.). The products obtained by these methods also have better mechanical properties (tensile strength, hardness). Part of the plastic deformation methods yielded ready-to-use outlets.
- Badges
- Science method
- Similar topics
- Methodology