Why permittivity of a material decreases with an increase in frequency of the voltage source?

I am lottle bit confused about that how permittivity of a material decreases with an increase in frequency of the voltage source? Kindly, explain this concept with some example or mathematical. Thanks

03 April 2019 8,107 6 View

Now, I am working on RFID based biomedical sensors. Can any body provide some useful data about this topic?

Basically, I want to design RFID based bio sensors. These sensor find out body temperature, heart rate, respiration level (SpO2). kindly, share some papers or data which help me in this field. I...

09 October 2018 9,078 0 View

White Gaussian Noise PSD is fixed No/2. So how we can investigate that noise variance is average power of the noise?

Prove the above statement in suitable way. Thanks

02 March 2018 6,646 0 View

How we can improve power factor, when load connected with induction motor?

As we know initially PF in case of induction motor is lower, but after some time PF becomes improve. Can any one explains that how we can improve the PF instead by using the parallel capacitor bank?

02 March 2018 7,741 5 View

How we find frequency response of the signal?

can any on help me that how can i find the frequency response of the given signal? The required signal image is given below.

09 October 2017 8,560 2 View

Can any one prove this question ?

Prove this linear algebra question which belong to matrix operations

08 September 2017 1,488 0 View

Can any one provide me Wind Turbine Free CAD design files?

07 August 2017 9,431 6 View

Can Any one tell me the correct answer with solution or tech about attached picture question?

07 August 2017 5,706 3 View

Kindly, tell me that how can find out the switching angles for 7 level H bridge inverter by using half hight method?

02 March 2017 5,096 1 View

By using Half Height method, I have calculated the main switching angle. How can calculate other switching angles by using these main angles.

the code for main switching angles are attach below.

02 March 2017 4,692 0 View

How can I integrate a routing protocol in a tiny device (e.g. Raspberry Pi)?

Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...

01 March 2021 9,332 6 View

Timeout error!! Processor in the loop (PIL) using STM32F4 Matlab 2018a?

Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...

01 March 2021 2,327 1 View

How to eliminate Steady state error from Reinforcement learning genetic algorithm code?

The following code (see 1st 2 images attached) is used to produce PID controller values that are designed to control the system (G). The code finds the PID controller values (noted as k) by using...

28 February 2021 6,560 14 View

How to prevent ANFIS Model from negative prediction values in MATLAB?

I have input and output data set for "ANFIS modeling in MATLAB", and I am getting some negative predicted values of output in testing. However, the predicted values of output in training are...

28 February 2021 3,459 3 View

How to improve and implement WBAN MAC and Radio modules under Castalia 3.2 ?

Hello researchers, Hello Castalia3.2 researchers I am a beginner with Castalia, I work on optimization of RFID systems used in wireless body networks. I simulated a WBAN with 10 nodes and one...

28 February 2021 400 1 View

How does an AC-DC power supply Flyback Converter Based USB Charger Model using Matlab/Simulink looks like?

I am required to learn about Flyback converters and I got stuck not knowing to full design of the power supply flyback converter Based USB Charger Model using Simulink, especially the design model...

25 February 2021 5,435 2 View

Please. Could you help be in implementing Fractal Discrete Cosine Transform algorithm in Matlab?

I do need the Matlab code of Fractal Discrete Cosine Transform (FDCT). Can anyone who has already implement this code, help me with the implementation of this transform?

24 February 2021 5,602 2 View

D2D implementation in Matlab in Vienna LTE software?

Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks

24 February 2021 9,378 3 View

Multi effect distillation modeling in EES?

Dear colleagues If anyone has a model of multi-effect distillation in EES or MATLAB software, please send it to me.

24 February 2021 7,282 1 View

What software programs can directly simulate Additive Manufacturing Directed Energy Deposition (DED)?

I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....

24 February 2021 4,428 3 View