How to decide the below or above resonance and what material for the particular frequency???
Which software is better for this???
You can use operational amplifier as a buffer (unit gain non-inverting amplifier)
For designing part you can use CST studio software. there you can find help to designing part as well.
what kind of design (op-amp based or RF circuit or any other) you require.
Basically, for RF circuits design ADS is the best software.
You would have mention frequency and application, so that better suggestions can be done......
Your question implies passive isolation, however you may consider active isolation. Also, what type of isolation, voltage, current, impedance or power. There is an abundance of software available, the best may be a pencil and paper and your brain... very affordable.
- Badges
- Science topic