Isothermal curve of palladium..
I have submitted my manuscript to Steel and Composite Structures Journal two days ago. However, until now, I have not received a confirmation email from this journal. At the end of the submission...
21 May 2023 9,358 4 View
To know the main reason for existence of galvanized steel core that can influence on magnesium or zinc anodes in cathodic protection system...
29 March 2023 4,789 2 View
Help me in finding corrosion research for master degree but can do it in simple chemical lab...
22 December 2022 3,959 4 View
Some alloys passivate simoltaneously and not exhibit active behavior, what is the reson?
11 December 2022 3,994 2 View
I want to apply a privacy-preserving algorithm in MQTT for IoT devices. Which tool do you suggest to simulate this algorithm? I want to measure the performance on the IoT battery device? Actually,...
28 January 2021 9,848 3 View
bibliographical references in thesis or paper or any scientific research
17 March 2020 2,782 3 View
Compared with traditional or overland PV systems, the floating PV systems can benefit from the natural cooling effect of water and operate with higher efficiency, since the decrease of the...
03 January 2020 2,923 23 View
I'am writing in reference to HFSS software. I would like to enquire about to study how can I obtain the reflectivity of silicon surface with structure air-silicon-air.
23 December 2018 8,485 0 View
Which is the best low-cost IOT embedded board available in the market?
08 September 2018 7,399 8 View
I would like to know from researchers who are working on IOT, Is it useful to use online data servers platforms like ThingSpeak or it is better to create my own platform?
09 April 2018 2,401 4 View
I conducted an adsorption experiment of arsenic on soil in the presence of different doses of silicon as competing ions to see the effect of silicon on arsenic adsorption and desorption. I took 5...
03 August 2024 6,500 3 View
Dear all, l need to help me to determine pore diameter. I got from BJH data the rp(peak area), Desorption Isotherm was 1.6 nm, but from Isotherm l got type lV with hysteresis H2 loop. Can l used...
10 July 2024 2,872 1 View
BET analysis
27 June 2024 6,964 1 View
I am conducting adsorption experiments in a liquid medium, and one of my samples showed a decrease in Qe values with an increase in Ce. Has anyone encountered this behavior before? What does it...
26 June 2024 7,304 2 View
What is the significance of the -ve 'b' value or -ve intercept for the linear Langmuir isotherm plot?? I recently plotted some of my experimental data in a Langmuir linear isotherm plot. I have...
18 May 2024 4,576 10 View
Dear everyone. I am biulding a TSA simulation in Aspen Adsorption. I do not have a single component feed stream, but a multi-component one. I am using the Gas_Dynamic "gas_bed" block. In the...
29 April 2024 6,290 0 View
what is isothermal? how to work it? explain the isothermal diagram? and also explain diagram ?
22 April 2024 9,339 1 View
The isotherms needs qe from different ce, in that case for both pseudo 1st and pseudo 2nd order there should be separate Langmuir and Freundlich isotherms. If in case of isotherm the research...
10 April 2024 1,578 1 View
What the correct calcultions of D-R isotherm model parameters, concerning the units of Ce and Qe in mg/L and mg/g to calculate adsorption Energy in KJ/mol
30 March 2024 4,533 1 View
I'm running the cyclic voltammetry in 1 M KOH by using palladium catalyst. Here I want to know for the ECSA calculations (ECSA=Q/m*405). However I couldn't find how to calculate the value of Q and...
28 March 2024 1,079 0 View
