If the microalgae experience stress through transportation. What would be the best course of action to avoid it from becoming contaminated or killed?

I am currently doing an experiment in my faculty lab and I need living micro-algae to be transported from other countries. The samples will be done in Morocco and Spain and they will be sent to...

08 September 2020 4,424 2 View

Can anyone suggest a recipe to deposit thin films of TiO2 on glass substrates using sputtering?

I need to deposit Titanium dioxide (TiO2) on a glass substrate using sputtering, any suggestions for a recipe that can get a uniform coating please

03 September 2020 5,232 5 View

What is the effect of the large scale of behavior particle in a magnetic field?

As it is known there is a magnetic field in large scale universe, so the particle undergoes a magnetic field will be different in case of expanding universe or static one as it will be in the...

13 June 2020 6,258 3 View

Why do I need to calibrate the spectrometer connected to an optical microscope?

I am taking some measurements using a spectrometer connected to a microscope. My aim is to know the spectral position of the resonant peak. As I know, I need to calibrate the spectrometer for...

02 July 2019 8,043 2 View

On which window was made the fast Fourier transformation because the main frequency is not very precise?

concerning now comparing the CSD to the noise power can you explain to me why should I do this because from what I got from the cyclostationnary spectrum sensor that it is based on the correlation...

20 October 2017 5,278 2 View

Whet is the relationship between the signal measurement noise and the variation in signal distance?

01 June 2016 4,538 3 View

How to choice some trees adapted to water deficiency is difficult in arid lands ? Was the adaptation more interest than genetic expression ?

04 February 2016 6,184 3 View

Can anyone help with a problem in Qst3?

I want ask about the QST3. I make the run and the message Lnk1e in /usr/local/gaussian//g09/l103.exe I used opt=CalcAll and tried Opt=CalcFC both give me the same message.

11 May 2014 2,965 3 View

How can I integrate a routing protocol in a tiny device (e.g. Raspberry Pi)?

Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...

01 March 2021 9,332 6 View

Timeout error!! Processor in the loop (PIL) using STM32F4 Matlab 2018a?

Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...

01 March 2021 2,327 1 View

How to improve and implement WBAN MAC and Radio modules under Castalia 3.2 ?

Hello researchers, Hello Castalia3.2 researchers I am a beginner with Castalia, I work on optimization of RFID systems used in wireless body networks. I simulated a WBAN with 10 nodes and one...

28 February 2021 400 1 View

What are the patterns of human behavior that lead to COVID-19 infections?

Does data from contact tracing help in establishing patterns of behavior and social interactions that lead to infections? There are cases here in the Philippines where patients have no travel...

25 February 2021 9,002 13 View

How to calculate battery consumption for IoT device?

Hi, everyone I'm working on a privacy-preserving algorithm that will apply to IoT devices. So, I need to measure the power consumption by implementing this algorithm. Any suggestion, advice,...

25 February 2021 8,749 6 View

Are there any databases for gene co-expression or expression pattern clustering?

I am currently working on gene clustering based on co-expression pattern in mouse brain. The problem is I do not have some solid way to test my result. Are there any suggestions for databases...

22 February 2021 4,374 3 View

How to simulate 5G Quality of Service characteristics?

For my research, I would like to simulate an end to end 5G network. My goal is to observe the behaviour of SDAP protocol, dynamic configuration of 5QI values etc. To summarize I would like to...

21 February 2021 7,624 3 View

How to increase coupling range (distance between reader and sensor coils) in LC resonance circuit?

Hello great researchers, I am working on a wireless pressure monitoring project where sensing part is actually an LC resonance sensor and I am using a planar coil as a reader to get wireless...

11 February 2021 4,148 5 View

I am looking for a microbend optical sensor design...can anyone please provide me some idea about it??

I am working on a landslide model...i need an optical sensor to determine the amount of pore pressure and other values..i am thinking of using a microbend sensor. Can anyone please provide me with...

11 February 2021 5,911 2 View

How to choose the Hidden Layers Number and RBM Size in a DBN network?

Hello, When using a Deep Belief network (DBN) for images classification, how could we choose the number of hidden layers (number of Restricted Boltzmann Machines) and nodes (RBM size) in a hidden...

09 February 2021 4,618 5 View