I think LC filter values load dependent so how i can choose adequate values for filter design
Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...
11 August 2024 8,141 3 View
How to use and this is economical?
06 August 2024 3,160 2 View
I am analyzing cherts from different sources found within one specific geologic formation using ICP-MS/ES. My committee was asking this question about my analysis. I was not sure how to answer this
05 August 2024 7,902 3 View
I am currently researching the impact of environmental toxins on children's health and would greatly appreciate insights from experts in the field. If you are an expert or researcher working on...
02 August 2024 2,627 1 View
Hi researchers! I'm working on soil texture analysis, and the end result for sand is doubtful because there is black sediment appearing after drying, as shown in the figure. Is it considered sand?...
30 July 2024 557 2 View
isolation of microplastic from sludge sample using centrifugation ..
23 July 2024 6,418 0 View
I want to know that n-doped side of solar cell is connected with positive or negative electrode.
20 July 2024 1,348 2 View
I studying PhD course in Urban design for Health. I need to know in some fileds: residental block, green open space and Transport TOD. I need connect with expert in that fileds.
14 July 2024 1,892 3 View
I am working on implementing a Kalman filter integrated with ARMA parameters, as described in the article "Predicting Time Series Using an Automatic New Algorithm of the Kalman Filter"...
12 July 2024 8,116 2 View
NA
11 July 2024 8,969 1 View