I am searching for the Post-doc from recognized institution at India or abroad. Will you help me for the same?

More Rinkesh Bhatt's questions See All

Do degrees of free -NH2 groups have always positive effect on biosensor properties ?

Conducting Polymers like Poly (aniline), Poly (diaminonaphthalene) and many more contain free -NH2 groups which will help to sensing biomolecules.

10 November 2017 3,863 0 View

Meaning of amorphous halo in the XRD patterns for a cryogel based on 2-hydroxyethyl methacrylate and acrylonitrile ?

Please describe the meaning of amorphous halo.

02 March 2017 4,047 0 View

Will Indian earthen clay pot (matka) violated Second low of thermodynamics?

Dear/ Respected all, Indian earthen clay pot (matka) cool the water (without external agency) as compare to higher atmospheric temperature i.e. it work as refrigerator without using external...

03 April 2016 804 2 View

Will Quasi-one-dimensional model explain the conductivity mechanism of conducting polymers in low temperature range?

Conducting polymers are chain like aromatic/aliphatic in nature and hopping mechanism applied on it.

02 March 2016 660 5 View

How does Reverse Indentation Size Effect affect the mechanical properties of polymer-polymer blend?

Respected All, Blend was formed by the combination of synthetic polymer and biological polymer as well gamma irradiated.

09 October 2015 3,415 1 View

Whether solvents did chemical or physical reaction with solute (monomer) during chemical oxidation polymerization?

Respected all, Different structural changes obtain with the treatment of different solvents. During the two step process, different solvents evaporate and the rate of evaporation was also different.

07 August 2015 5,010 0 View

What is the meaning of negative coefficient of kurtosis obtained in my specific AFM sample?

Kurtosis moment is the fourth moment of profile amplitude probability function and corresponds to a measure of surface sharpness. Even than negative value ? Table is attached with this question.

04 May 2015 10,166 7 View

Why do I get a negative slope in the Williamson-Hall plot for my sample?

My sample was ZnO doped PVA film. There is negative slope obtained from plotting the graph to find micro-strain. Could you explain the results so obtained ?

04 May 2015 4,179 7 View

Polymer wear calculation?

What is the method for analytically calculating the wear and service life of polymer-polymer sliding pairs?

04 August 2024 1,078 1 View

How to explain the different interaction between soluble and insoluble polymer in water?

Hello everyone, I am try to understand the differences interaction between insoluble and soluble polymers in water with metal ions and how theit charge density (of metal ions) affect the interaction.

29 July 2024 6,350 3 View

I want to buy Hydrothermal Synthesis Autoclave from any European company. Can anyone suggest any company inside Europe?

Thanks

22 July 2024 1,143 3 View

Is it possible to manufacture polypropylene sheets using a biaxial process?

I know that films and other low-thickness laminated products are produced using biaxial orientation, but is there something similar for sheets with a thickness of around 6 mm? Or are they...

21 July 2024 1,559 1 View

Hi dear researchers, do you suggest the best and shortest path for chemical synthesis and green synthesis of magnetite(Fe3O4)?

Suggest the best and shortest route for the chemical synthesis and and green synthesis of magnetite(Fe3O4) The chemical synthesis should contain the least dangerous chemicals along with full...

21 July 2024 2,476 2 View

What is the difference between coordination polymer, MOFs, MCOFs?

Wherever I have referred, it puts me in a dilemma about the exact differences between these. It would be really helpful if someone can put me out of this trouble.

21 July 2024 3,045 3 View

What is the harnessing rainwater harvesting for climate change adaptation and how is India trying to ensure rainwater harvesting?

20 July 2024 6,041 2 View

Appearance of crystallization peak in heating cycle of DSC test?

For which types of polymers, the crystallization peak in heating cycle of DSC test can be observed and for which types cant? In another word, when this exothermic crystallization can be observed...

18 July 2024 348 3 View

Interpreting ATR-FTIR Spectra for Microplastics Research?

Hello everyone, I am currently pursuing a PhD in Environmental Engineering with a focus on microplastic studies. My background is in Civil Engineering, and I am relatively new to working with...

18 July 2024 7,258 3 View

Identity behind this address?

May I request for change of pofile for this email address? It belongs to the ofice of the head of institution but the name attached is different. Kindly also include [email protected] being the...

17 July 2024 1,145 0 View

Rinkesh Bhatt

I am searching for the Post-doc from recognized institution at India or abroad. Will you help me for the same? Edit

I did my research work in conducting polymer (synthesis, characterization and its application).

I attached the application related to above mention post.

Thank you for your kind persuasion.

Sunil Dutt

Dear Dr. Bhatt,

Its better to apply for funded projects with mentor....like N-PDF in India and other fellowships for abroad..