How to resolve Error 2000-01, Feeder is not selected in VVO?

More Faustinus Chinedu Ilo's questions See All

Are you experienced in ETAP, could you provide some technical support for a Power Distribution Network Analysis?

I'm currently on a Power Distribution Network Analysis study. I need some technical assistance with Optimal Capacitor Placement and Optimal Power Flow. Thanks for the anticipated feedback.

22 August 2021 8,282 1 View

Request for collaboration in Power Distribution Analysis Studies?

I am doing some academic research in Network Analysis using ETAP. Study scope includes Voltage Stability, Harmonics, Reliability Assessment, Transient Stability, Optimal Power Flow, Switching...

08 August 2021 2,640 5 View

Simulation for optimizing MVAR absorption in a 500kV network on a power generation system using ETAP software....?

I need advice and suggestions. I want to simulate the operation of a generator to absorb MVAR in a 500kV network. How should I proceed with the simulation using ETAP? How can I set the parameters...

19 June 2024 6,838 0 View

Etap software simulation ?

How can I include a STATCOM device in ETAP 12.6 ?

13 May 2022 796 0 View

I am new learner on ETAP software, I wanted to do a harmonic analysis in a zone of a factory, ?

the problem I have is that I have automatic compensation batteries while in ETAP DEMO I have just static batteries can I make a series combination of static batteries to model the automatic one

09 May 2022 4,297 0 View

Are you experienced in ETAP, could you provide some technical support for a Power Distribution Network Analysis?

I'm currently on a Power Distribution Network Analysis study. I need some technical assistance with Optimal Capacitor Placement and Optimal Power Flow. Thanks for the anticipated feedback.

22 August 2021 8,282 1 View

Request for collaboration in Power Distribution Analysis Studies?

I am doing some academic research in Network Analysis using ETAP. Study scope includes Voltage Stability, Harmonics, Reliability Assessment, Transient Stability, Optimal Power Flow, Switching...

08 August 2021 2,640 5 View

How to characterize different elements of power system in per-unit in ETAP software?

I am trying to make a power flow analysis for a specific power system configuration, but the given voltage at the slack busbar is in per-unit. The transmission lines impedances are also in...

20 May 2021 9,692 3 View

Any one know how to solve with my ETAP 12.6?

I am using ETAP power station 12.6 Enterprise version, and I want to try GIS module, and it shows this comment: " ESRI GIS system not installed! ETAP GIS functionality can't work without ESRI GIS...

26 October 2020 9,996 2 View

How can I set up Swing Voltages to be higher than 1pu in ETAP?

I am currently modelling the IEEE 13 Node Test Feeder in the ETAP 19.5 student version. I am trying to circumvent the difficulties presented by the voltage regulator (since the regulator module...

02 May 2020 941 1 View

How to measure Line Frequency in EMTP-RV software?

I am using IEEE-39 bus benchmark system in the EMTP-RV software, performing short circuit fault analysis studies on the transmission buses. Can someone please specify how we can measure the line...

29 September 2019 3,216 0 View

How can i synchronize GIS to ETAP software?

how can i synchronize GIS to ETAP software?

09 October 2018 7,622 1 View