Air quality, Particulate Matter
Please find the attached link about monitoring and measurements of PM1.0
http://www.ppsthane.com/blog/particulate-matter-measurement-pm
Regards
You can either use a commercially available PM1 sampler (Envirotech, Tisch, etc.) or set up your own sampling system by assembling a vacuum pump, a sharp-cut PM1 cyclone and suitable filter packs with or without denuders.
Indigenous pm 1 samplers are yet to be precise while their accuracy are required to be validated. You should go for Tisch
How the e-governance has little value in educational institutes/schools/colleges/universities?
03 April 2018 2,529 5 View
How the e-governance has enhanced relevance in educational institutes/schools/colleges/universities?
03 April 2018 1,824 4 View
Dense fog during 13-16 Dec, 2017 disappeared thereafter..
11 December 2017 1,065 0 View
Significant pollutant affecting crop plants.....
11 December 2017 6,111 7 View
Climate change, regional environment degradation.
01 January 1970 5,358 0 View
Environmental degradation, ethics.
01 January 1970 8,558 0 View
01 January 1970 3,172 0 View
Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...
02 March 2021 4,910 3 View
When you use RIA, with a control the unknown sample with antibodies, you bare in mind the binding sites of the antibodies. However you still need to measure labelled antigen (radioactive) and not...
28 February 2021 2,133 3 View
I like to do project in laser measurement system. My objective is to eliminate or reduce the cosine error, abbe error in Laser measurement system. I have Rhenishaw XL80 system. Please tell the...
28 February 2021 4,890 3 View
Dear All, We are using Autodesk cfd to calculate the air flow in a single sided naturally ventilated room, where air flow depends only on buoyancy due to temperature difference between inside and...
25 February 2021 9,602 4 View
25 February 2021 1,987 3 View
As it is highly probable that pellets will have a higher degree of air gaps and voids than thin films, is it possible to pole the samples with corona poling nevertheless? Or is there the...
24 February 2021 1,349 1 View
Dear all, My research group is currently working with a 12-litre fermenter. Somehow, if we do the fermentation for more than 20 hours, the process will be more prone to contamination. Our current...
23 February 2021 1,908 2 View
Hello, I created a very tall tower (>1000m) and applied pressure boundary conditions at the inlet (bottom) and outlet (top) that correspond to the pressure are their relative altitudes....
22 February 2021 9,972 4 View
Could the "incoming solar radiation" values be negative? What is the difference between "global solar radiation" and "incoming solar radiation"? Which one might be measured negative values?
21 February 2021 7,726 9 View
My team is designing a dual channel microfluidic chip that runs air and water. I think we've decided on the NE1000 syringe pump for it's versatility and feedback control. We will be ordering the...
18 February 2021 9,928 2 View