How to measure heat distribution of a sample?

More Arnas Žemaitis's questions See All

Is there a way to filter out 10nm particles form gas, while maintaining low pressure (up to 1bar) in the system?

07 August 2019 4,501 1 View

Which type of compound does lamda max of 218 indicate in a uv-vis spectrum of a partially purified compound through column and TLC?

A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...

11 August 2024 9,801 2 View

Using OBD technique i am trying to measure laser induced shockwaves velocity i found that at start velocity increases and then decay?

i am unable to interpret why its increases in start as shown in figure

11 August 2024 2,179 1 View

Hello researchers Is this a random laser or just fluorescence?

I am using Rhodamine6G as gain medium and silver nanoparticles as scatterers on a microscope slide and laser input 532 nm comes from above.

09 August 2024 9,894 2 View

U you think We need a website software of Blackbody radiation law expert software?

A website software of Blackbody radiation law expert software can used through the following web site. http://39.105.188.151:3000/index

07 August 2024 1,706 0 View

Could dyes amplify the spectrum of light to a specific wavelength?

I am interested to know the behavior of dyes toward light. Specifically, Blue dyes re-emit the spectrum, especially from the green zone (known as principal in LED lamps, and blue dyes are known...

05 August 2024 3,290 1 View

Can a Conventional 50W visible LED Lamp Emit UV Light?

I'm researching light sources and their UV emissions. I'm curious if a 50W, 7500K conventional LED lamp emits any UV light. I found that a 200W tungsten lamp can emit up to 1.5 mW/cm² at 350 nm....

31 July 2024 3,843 7 View

How can we calculate the percentage of configuration interaction (CI) in the UV output data of the Gaussian program?

How can we calculate the percentage of configuration interaction (CI) in the UV output data of the Gaussian program? for example: Excited State 17: Singlet-A 5.1359 eV 241.41 nm...

28 July 2024 9,165 2 View

How should operational parameters be selected when developing a pore-free laser welding technology?

There are three operating parameters - the laser power, the diameter of the focus spot and the scanning speed. It is necessary to obtain a seam of a given depth without pores. What parameter...

27 July 2024 7,168 2 View

Can we fit a gaussian Fit on a LIBS Peak ?

Though much literature suggests fitting a Voigt profile on a LIBS peak, is it also possible to fit a Gaussian profile on the LIBS peak? I have 204 spectra files, and I am building a pipeline for...

23 July 2024 6,127 1 View

Is there a good macro photography kit for on-site metallurgical investigation?

I am looking to purchase a photography kit for onsite metallurgical investigations, such as capturing photos of worn areas, hot tears, cold tears etc. Could anyone suggest me a good...

22 July 2024 3,490 2 View

Srini Vasan

There is a method called holographic interferometry. Maybe this would work as a no contact measurement method?

Jörn Bonse

A reviewing chapter on "Thermometry in Laser Micro/Nanofabrication" was recently published here. The RG-link below provides the fulltext.

https://doi.org/10.1007/978-3-319-69537-2_48-1

Chapter Thermometry in laser micro/nanofabrication