Cartridge is not loading.
Hello everyone, we were working on some bacterial mixture, and want to sequence the 16S region, so the primer pairs sequences are needed. Can anyone help me?
26 June 2022 1,205 4 View
Can anyone help us to figure it out?
23 February 2015 8,965 6 View
We have observed that tube to tube sheet joint leaked in our boiler and needs to overcome same by knowing the root cause.
08 August 2024 3,161 0 View
For a grid connected BESS (lets say 100 MW/200 MWh system, LFP battery), if we charge the BESS in such a way that whenever we can access power from the solar that will charge the BESS. Hence it...
01 August 2024 9,903 7 View
I need to Postfix mice brains. I slice the brains using microtome at 40 microns. These are Postnatal days 7, 11, 14, and 21. I am using half the brain for other analysis, so I need to fresh freeze...
31 July 2024 1,123 4 View
how to fix this error, from phq_readin : error # 1 DFPT with the Blochl correction is not implemented I am attaching my ph.in file.
23 July 2024 4,649 2 View
> library(meta) Error: package or namespace load failed for ‘meta’ in loadNamespace(i, c(lib.loc, .libPaths()), versionCheck = vI[[i]]): there is no package called ‘numDeriv’
18 July 2024 3,536 0 View
I have a problem with geo-referencing a shape file. How can I fix it when it appears in mines despite selecting WGSWGS 84 / UTM zone 38N?
18 July 2024 2,696 1 View
Hi everyone I have got this test in a fixed excitation and various emissions. In some wavelengths there are overflows which make the resulted analyze different from other carbon dots. Is it normal...
18 July 2024 4,244 2 View
I suspect my cells are contaminated with mycoplasma. I fixed the cells with 4% PFA and stained them with DAPI. Below is the image I obtained. I don't observe the typical small, rounded DAPI foci...
11 July 2024 7,786 3 View
Hi, I'm working on heart flow cytometry, and I use anti-mouse CCR2-BV785 (biolegend, cat150621) for staining, 20 minutes, 4 degree. But I couldn't see any CCR2+ cells. So I'm not sure if it's...
03 July 2024 3,969 4 View
I'm trying to fitting Cu Auger peak into various state (Cu0, Cu+, CuI etc..) In Cu0, one of the peak's FWHM is 0.84 but when I try to enter smaller value than 0.89, "input error" is occured. How...
02 July 2024 4,932 3 View
