Please suggest some experimental and numerical literature to study heat loss and temperature distribution with heat generation in electric motors.
please refer to Electrical Machine design book by S V Deshpande.
I have done a steady simulation of an optimized case using K-Omega SST turbulence model .I have an optimized model for a low speed application and the operating condition is fixed.The benefit, as...
08 September 2014 3,793 21 View
From contour plots on a surface having interface boundary, a jump in the value of a variable is observed. Well, this does not happen with interior boundary. So is there any fix for this?
02 March 2014 4,168 5 View
For inlet axial velocity / tangential velocity of the rotor. Such high values does not occur in a conventional low speed single stage compressor (rotor and stator).
01 February 2014 677 1 View
I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...
08 August 2024 717 0 View
I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...
07 August 2024 1,027 0 View
Hi! So i attempted to understand a novel protein behavior towards heat application by analyzing its secondary structure change. I subjected the protein to a thermal denaturation analysis using...
06 August 2024 1,988 3 View
is there any other way to heat a polymer evenly other than oil bath if so what are those and how to use it
06 August 2024 946 1 View
I am seeking experimental or applicable data for the liner (LLDPE) interface in FLAC3D numerical modeling of a large stockpile. Could you please recommend suitable references? The preferred data...
05 August 2024 3,665 0 View
I want to Estimate surface heat fluxes using MyLake, but I don't have all the initial values in model parameters section and other sections,is there a way?
04 August 2024 1,535 1 View
My screen printed electrode CV is given here. For Nerstean one electron reaction the delta E value should be close to 57 mV and ration of Ic/Ia should be close to 1. I did CV of my screen printed...
30 July 2024 4,671 3 View
A computational study of heat flux on cylindrical surfaces using CNT hybrid nanofluids
28 July 2024 4,984 1 View
I would like to conduct artificial sunlight experiments to mimic heat capture and air warming in a greenhouse system. The main objective is to heat up the temperature inside the greenhouse, not...
28 July 2024 4,006 2 View
Hey researchers! I am currently doing a research about to what extent in which A has accelerated the inclusiveness of the payment system in my country. Down below are a few examples of the...
26 July 2024 5,654 3 View