Hi everyone,
I want to design a half-wave dipole. Length of the dipole must be depend on frequency (or wavelength). Therefore, i want to use the analysis frequency as a variable in the program. Is there anyway to do this? Is there any default name for frequency variable like intrinsic variables in HFSS?
Thanks.
Hi, Hope all is well. You can use sweep parameter tool where you can define a range for the length of dipole in term of frequency. After simulation, all results at these values will be shown in the same figure.
Hager S. Fouda Thanks for your reply. But, how to define the length in terms of frequency? Has it a special name? I want to use the fequency value, which is also used by the program. So, length of the antenna will be adapted for each analysis frequency in a multifrequency simulation.
- Badges
- Science topic
- Similar topics
- Biological Science
- Bioecology
- Systems Ecology
- Landscape Ecology
- Connectivity