Measurement of magnetoelectric current (density) seems to be very popular to investigate the magneto-electric response of multiferroics. It'll be grateful to know how it is measured and about the protocols.
Hello,
https://iopscience.iop.org/article/10.1088/0953-8984/11/16/014/pdf
Article Magnetoelectric effect in cylindrical topological insulators
Thanks
We often see two relation for calculation the dielectric permittivity: (1) E= C/C0 where E = dielectric permittivity, C = capacitnace and C0 is the geometric capacitance. (2) E =...
05 June 2017 706 3 View
I have received the following attached mail for a long time. I can not understand it. please see it.
01 February 2017 2,270 0 View
It is reported that several important pervoskites like SrTiO3, BaTiO3 have surface layers that are structurally different from the interior of crystal. Further, it can show transition similar to...
07 August 2016 6,079 8 View
I am working on orthoferrites and studying their dielectric properties. One of the samples I prepared shows a dielectric relaxation peak (observed in real part of dielectric constant, at high...
01 February 2016 2,368 6 View
What is the Quantum Effect in ac conductivity?
01 February 2016 3,407 3 View
I got the following Nyquist plot, measured in a frequency range of 100Hz - 1MHz by an Waynkerr LCR meter. I am trying to model an equivalent circuit for it and tried a lot using CPE also, but not...
01 February 2016 8,029 7 View
Previously, I successfully modelled the transmission and reflection of electromagnetic waves incident on non-magnetic materials. Please refer to my publications for details: 1- A polynomial model...
05 July 2024 1,396 2 View
i have attached my model and i have used point based mesh independent fastener using attachment points and type of connector is basic cartesian but this is not working as i apply displacement on...
02 July 2024 6,293 0 View
Magnetohydrodynamic generators are normally used as eihter an attachment to recycle wasted heat and flow of other generators, or used to absorb the energy from rocket thrusters. However, I'm...
24 June 2024 3,949 1 View
I'm not an electrical engineer or anything related to that subject, so my apologies if I understood something incorrectly. Well, I read somewhere that the slower the railgun is, the higher its...
23 June 2024 1,082 0 View
I am running a coarse DNS case for pipe flow with 2.1 Million cells. My residuals are quite fluctuating as its a fully turbulent annular pipe flow case but its getting statistically converged to a...
29 May 2024 2,063 5 View
Let's consider two windings containing thin diameter wire(0.3 mm) and thick diameter wire(4 mm). These windings operate under the following conditions. 1- The same power is applied. 2- They have...
22 May 2024 7,255 5 View
I searched in literatures and i got the formula root length of treated plant / original root length *100 when i applied this, i got the values higher than 100.
10 May 2024 9,148 2 View
I intend to apply this method to solve electromagnetic problems (governed by Maxwell's equations) with different scales in them. Is it possible and does it have any advantages?
07 May 2024 4,071 0 View
I have seen that some lecturers claim the leakage flux of a transformer will automatically become zero in case it has an ideal iron core. I want to say NO! This is correct for a system with a...
03 May 2024 4,010 14 View
This question is still relevant since the discovery and description of photons more than 100 years ago. If we follow QM theory, the answer is definitely no because the photon must have a positive...
01 May 2024 4,440 1 View