How do nano clay Montmorillonite particles affect the strength and microstructure of cement based materials?

Seyedyashar Seyedahmadian @Seyedyashar-Seyedahmadian

28 September 2023 1 4K Report

Hello

The effect of nanoclay on the strength will mainly depend on the percentage weight of nanoclay added and the type of cement material you are using as well as which type of strength you are measuring (compressive, tensile, flexural, impact, ...).

This is a very interesting review about the effect of nanoclays as fillers on different material properties.

Article Mechanical and Impact Strength of Nanoclay-Filled Composites...

Badges
Science topic

What is Nano technology with coronavirus helpe the human..and is it nano mterals removal of covid19?

I anwar by adsorption or reaction ..but it is either more method...

02 March 2021 4,811 2 View

How to compare different concentrations of nanoparticles for characterization from ICP-MS?

I took measurements of different concentrations of 15 nm and 5 nm Au nano particle solutions. I'm trying to determine which concentration I measured gives the best reading overall. I also...

02 March 2021 7,626 1 View

LEDs on Vis Light photo degradation of MB water sol via N doped TiO2 in a mini flume?

Good day to all, I have no experience with light emitting diodes. I am building a glass mini flume to demonstrate the photo degradation of Methylene Blue in water running over self cleaning...

26 February 2021 4,026 5 View

Zno nano particles colour changed from white to grey in process of calcination any suggestions?

In the formation of Zno nano particles process, after drying at 120 degree C, my zno nano particles are completely white but when i calcine it for 450 degree C it converts into grey colour. i...

26 February 2021 2,435 4 View

Compute for the total volume of concrete needed for the concrete pouring of the foundation including its column up to NGL only as shown in the plan?

Looking for the quantity of cement, sand, and gravel of footings and columns. Thank you!

25 February 2021 3,092 2 View

What is the best solvent to remove PDMS from nano particles?

I want to remove PDMS oligomers from the surface of nanolayers. I have just read a very helpful paper about the compatibility of PDMS with different solvents( Solvent Compatibility of...

24 February 2021 7,845 5 View

QPCR tubes for Roche Lightcycler Nano?

We own a small cPCR thermal cycler from Roche, Lightcycler Nano, which is convenient for backup quick runs. Recently, Roche has discontinued the plastics for it and they offer no alternative from...

17 February 2021 8,694 5 View

Best synthesis method for large scale silver nanoparticle synthesis with high yield?.Best post processing steps after nanoparticle synthesis?

I have chemically synthesized silver nanoparticle to combat microbes on wound site. I have used many methods of synthesis, but I found minimal field of silver NP product.I am getting whitish...

11 February 2021 4,964 13 View

For acid treated montmorillonite clays what will be the result of surface area?

The organo montmorillonite nanoclays modified with octadecylamine were used for the experiment. After acid treatment, the surface area will be increase. However, in my experiment, the surface area...

10 February 2021 1,581 3 View

Dear colleagues. How can we implement the kinetics of the polymerization of aromatic amines in easier and simpler ways?

Dear colleagues. How can we implement the kinetics of the polymerization of aromatic amines in easier and simpler ways? Are there simpler methods for Nano polymers (other than those obtained with...

09 February 2021 5,783 3 View