How to use fuzzy logic to regulate voltage and frequency of a microgrid?

using fuzzy logic is an improved droop control. it is represented in the attachment paper. i didnt get it well. in the method do we calculate R and X of a line to use them in the GDC (generalized...

09 October 2016 6,479 4 View

How to write the rules in the FLC?

look at the attached file, table 1 and the highlighted sentence. i need to write 36 rules but according to the ith fuzzy rule is written the paper (bottom the paper) the rules are written like...

09 October 2016 750 6 View

I am receiving the following error msg in my simulink model, what should i do?

09 October 2016 5,187 20 View

How to share properly active and reactive powers between DG units?

06 July 2016 6,772 15 View

In microgrid, when there are 2 or 3 DG units connected in parallel, should they work in the common reference frame? How?

for conventional droop control, when microgrid is in islanded mode and several DG work in parallel. for simulation, How to translate the variables from an individual inverter reference frame onto...

05 June 2016 1,853 8 View

How can i simulate inverter_based DG in matlab simulation?

i want a microgrid sys with two sets of DGs. DGs are inverter_based. i should use which block for inverter. please help me by an example in matlab enviroment. plaese check the attachment. i want...

01 February 2016 6,305 8 View

Logistical regression using SPSS for a dichotomous dependent variable, with an independent variable of 1, 2, 5 and 10 seconds?

I have an experiment with 28 participants The independent variable is the times 1, 2, 5, and 10 used as the cross hairs during a task These 4 times were tested using 4 different blocks, each...

03 March 2021 9,692 2 View

Sample dilution for quantitative analysis using ELISA?

If the detection range is in ng/ml but the reference range is in ug/ml for a molecule or protein in serum or plasma .how to dilute and what is the initial volume to be taken for quantitative analysis

02 March 2021 7,670 3 View

Timeout error!! Processor in the loop (PIL) using STM32F4 Matlab 2018a?

Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...

01 March 2021 2,327 1 View

How to eliminate Steady state error from Reinforcement learning genetic algorithm code?

The following code (see 1st 2 images attached) is used to produce PID controller values that are designed to control the system (G). The code finds the PID controller values (noted as k) by using...

28 February 2021 6,560 14 View

How to prevent ANFIS Model from negative prediction values in MATLAB?

I have input and output data set for "ANFIS modeling in MATLAB", and I am getting some negative predicted values of output in testing. However, the predicted values of output in training are...

28 February 2021 3,459 3 View

How does an AC-DC power supply Flyback Converter Based USB Charger Model using Matlab/Simulink looks like?

I am required to learn about Flyback converters and I got stuck not knowing to full design of the power supply flyback converter Based USB Charger Model using Simulink, especially the design model...

25 February 2021 5,435 2 View

Please. Could you help be in implementing Fractal Discrete Cosine Transform algorithm in Matlab?

I do need the Matlab code of Fractal Discrete Cosine Transform (FDCT). Can anyone who has already implement this code, help me with the implementation of this transform?

24 February 2021 5,602 2 View

D2D implementation in Matlab in Vienna LTE software?

Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks

24 February 2021 9,378 3 View

Multi effect distillation modeling in EES?

Dear colleagues If anyone has a model of multi-effect distillation in EES or MATLAB software, please send it to me.

24 February 2021 7,282 1 View

What program can I use to caclulate dipole moment efficiently and without the need of excessive computation?

Hi, I am a third year chemistry undergrad doing my group project in which I need to predict the HPLC retention time of 20 aromatic molecules. to do this we require the chemical properties of these...

24 February 2021 1,384 3 View