RIA. How to measure?

When you use RIA, with a control the unknown sample with antibodies, you bare in mind the binding sites of the antibodies. However you still need to measure labelled antigen (radioactive) and not...

28 February 2021 2,133 3 View

How to Eliminate cosine error and abbe error in LASER measurement system(for example Rhenishaw XL80)?

I like to do project in laser measurement system. My objective is to eliminate or reduce the cosine error, abbe error in Laser measurement system. I have Rhenishaw XL80 system. Please tell the...

28 February 2021 4,890 3 View

How to use measure capacitance change in COMSOL time dependent study ?

I want to measure change of capacitance due to relative displacement between two parallel plates in COMSOL. Distance between two plates changes with time. So I'm using a time dependent study but...

26 February 2021 8,567 3 View

How to measure angle between laser travel path and machine axis in Laser Measurement system?

25 February 2021 1,987 3 View

Could the "incoming radiation (net radiation)" values be negative?

Could the "incoming solar radiation" values be negative? What is the difference between "global solar radiation" and "incoming solar radiation"? Which one might be measured negative values?

21 February 2021 7,726 9 View

Can I follow Researchers from Teaching and testing areas?

I want Researchers from Educational Measurement and Evaluation, relating to teaching, learning , academic performance and test validation

18 February 2021 4,757 13 View

How to find the capacitive response frequency from the impedance plot?

I have done electrochemical impedance by using cyclic voltammetry for one organic material. from that, I plotted bode diagram. but actually, I am very confused about how to find the capacitive...

18 February 2021 3,023 3 View

How to get better phase shift in C-V curves for ferroelectric devices?

I tried to sweep my ferroelectric devices from -2V to 2V and then from 2V to -2V and The two hysteresis peaks are off by several microFarads. Should i increase bias voltage? I am doing these...

16 February 2021 8,514 2 View

How to determine measurement uncertainty of a mass balance?

Hi everyone, I work at a factory plant where they use a mass balance. The problem is that there is an huge difference between the input and output of one element. There are several people working...

10 February 2021 5,764 3 View

Where can I find the Affiliate Stigma Scale developed by Mak and Cheung?

Need the scale for a dissertation. Would be better if I could get it for free since my work is not funded. I need the English version of this scale.

09 February 2021 4,022 3 View