I'm trying to use full polarimteric method (HH HV VV VH) in order to reconstruct the image. I'm using a mutistatic architecture and while one antenna transmits, others should receive its co/cross polarized signal.I know the theory but I don't know how to perform it in HFSS or CST. I need to measure the amplitude and the phase of these signals in each location.
Firstly, does any specific antennas should be used for this purpose or I can do it with simple open-waveguide antennas?
Secondly, I have read paper about remote sensing, SAR and through-wall-imaging and this method was used in them, however, there are all in the farfield zone. I would like to get the data from polarization in nearfield.
I would really appreciate it if anyone has any clue
It is you who will propose the kind of polarization and then inject it into the simulator
Mohammed Berka Yes, but I don't know how I can do this. I'm trying to solve a scattering problem here.
For dispersion, you will draw the frequency-constant phase characteristic, you must share the setup in Analysis - setup before running the simulation !
- Badges
- Science topic
- Similar topics
- Design
- Architecture