SSSV is installed 100 FT deep in a production tubing 3-1/2" 13%CR NVAM
Pressure buildup at well head (WHP) is 50 PSI/MIN
Initial WHP=zero
Reservoir pressure is 6500 PSI
Reservoir depth 14,000 FT
Formation fluid is Gas & Condensate
Gas Liquid Ratio (GLR) = 10000 SCF/BBL
Barry Nicholson
Use a simple pipefllow program with 6500 psi on one side and adjust the pipe diameter until you get the observed pressure build up response. Use gas only as the fluid. Or just use Boyle's law for a rough estimate.
0 votes
0 thanks
Diego Fernando Campos Plazas
using this formula
q=35.37(P/Z-Pi/Zi)(1/t)(V/T)
q; scf/min
P; psi
t; min
V; ft3
T; °R
0 votes
0 thanks
- Badges
- Science topic
- Similar topics
- Engineering
- Petroleum Engineering
Similar questions and discussions