Greeting everyone; I’m going to design an optimum design of multiple fin arrays ( I have attached a schematic of that system).
Best Regards.
1. Yes, it can be considered as internal forced convection
2. This paper described detailedly the NU.
Look at this doc it may be helpful for your topic. Good luck
Dear Dr. Ma
I do appreciate your attention to my question and your answer.
In order to your suggested paper, I would like to know that what kind of heat sinks are considered in the realm of microchannel ?
Sincerely yours.
Dear Mr. Boulahia
Thank you for your answer and suggestion.
when Hydraulic diameter Dh
This doc will be helpful
Thanks a lot for your answer.
Dear Mr. Dhandapani
Hello everyone I’m going to calculate the convective heat transfer coefficient in a channel (or Duct). What is the most accurate correlation for the Nusselt number in channel for 2300
11 December 2016 7,406 12 View
Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...
10 August 2024 6,493 1 View
What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?
29 July 2024 7,714 4 View
In some data sources it has been grouped in Q1 and some shows it is Q2.
29 July 2024 4,227 2 View
Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...
28 July 2024 5,771 2 View
Contemporary scores or innovations in scientific approaches. Hybrid methodologies, emerging themes and cross-cutting issues?
27 July 2024 648 3 View
"The Correlation between Nutrition and Transport Mechanism under Abiotic Stress in Plants: A Comprehensive Review" by Muhammad Saleem, Jianhua Zhang, Muhammad Qasim, Rashid Iqbal, and Li Song,...
23 July 2024 9,109 0 View
// interested in the difference between floating events and short circuits.
22 July 2024 6,565 0 View
I am looking to purchase a photography kit for onsite metallurgical investigations, such as capturing photos of worn areas, hot tears, cold tears etc. Could anyone suggest me a good...
22 July 2024 3,490 2 View
I need to know the approximate size of my target protein for Negative-stain EM. I have an alpha-fold predicted structure of the protein. I do not see any turtorial on internet for estimating the...
21 July 2024 5,732 3 View
Research being conducted by Stellenbosch University would like your opinion about the effects of social exclusion on emerging urban mobility options and traditional public transport services. By...
21 July 2024 4,032 0 View