I am trying to build a WSN using IoT component XBee. I need to assign MY 16 bit address to each node(XBee S2) but I am not able to do this using XCTU. Is there a way around?
please see the below links
what Iot platform are you using?
is it IBM Bluemix or someother
http://www.arduino-hacks.com/xbee-communication/
https://learn.sparkfun.com/tutorials/exploring-xbees-and-xctu/configuring-networks
following
05 June 2016 2,615 2 View
04 May 2016 8,509 1 View
I need to connect an HBM K-LY 4/120 strain gauge(Linear 2 wire) to HBM QuantumX MX1615B DAQ system. This will be mainly done for the calibration of a custom built amplifier circuit. Although...
11 December 2015 8,005 2 View
I connecter 3/3v to pin1 ground to pin 10 and sensor input to pin 20. But the XBee isnt powering up. I cant identify any problem. Please explain
08 September 2014 5,485 3 View
07 August 2014 6,155 8 View
Currently I'm working on the launching girder used for Incrementally launched bridges. I need to model it in Inventor to get the stresses and strains during the launching process. However I am not...
11 December 2013 4,888 11 View
Is there a powerful system for the security of the systems distributed on IoT systems?
02 March 2021 3,858 10 View
The Lanthanide contraction which is the decrease in ionic radii of the elements in the lanthanide series from atomic number 57, lanthanum, to 71, lutetium, is due to poor shielding of the 4f...
01 March 2021 2,272 4 View
Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...
01 March 2021 9,332 6 View
Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...
01 March 2021 2,327 1 View
Hello researchers, Hello Castalia3.2 researchers I am a beginner with Castalia, I work on optimization of RFID systems used in wireless body networks. I simulated a WBAN with 10 nodes and one...
28 February 2021 400 1 View
I am working on developing a micromechanical FE model for predicting kink-band formation in UD composites. To model matrix plasticity, which model, out of Concrete Damaged Plasticity and...
28 February 2021 5,415 1 View
I am working on TiO2 composite material and the results of XRD have a lot of small/junk peaks and while I apply a smooth filter in Origin then the other characteristics peaks disappear so anyone...
26 February 2021 8,183 3 View
Does data from contact tracing help in establishing patterns of behavior and social interactions that lead to infections? There are cases here in the Philippines where patients have no travel...
25 February 2021 9,002 13 View
Hi, everyone I'm working on a privacy-preserving algorithm that will apply to IoT devices. So, I need to measure the power consumption by implementing this algorithm. Any suggestion, advice,...
25 February 2021 8,749 6 View
Im looking for any papers, reports,articles, links etc on information on How vulnerable is water and wastewater infrastructure to cyber terrorism in an age of IoT.
24 February 2021 2,750 4 View