I m interested in construction noise. I had a look to the British Standards but the value seems too high. Thank you in advance for your help
Can someone suggest any good paper/book? I'm also interested in your personal opinion.
04 May 2018 340 0 View
I'm modelling HDD drilling activity, does anyone suggest a paper?
03 April 2018 4,074 0 View
I'm interested in people reactions to other people's disease. I'm looking for papers/books. Does anyone know if there are open researches or studies?
09 October 2017 5,701 0 View
I'm interested in Airport Ground Operations Noise. Does anyone some suggestions about research papers/book/studies?
31 December 2016 3,456 2 View
Hi everyone, I'm an Italian Engineer with about 15 years of experience. I have a PhD in Industrial engineering, I work in London and I like to became a member of the Mechanical Engineers Order. I...
04 May 2016 3,753 2 View
which courses I need to attend or which examination I need to take to be recognize as co-ordinator for construction sites. Thank you in advance for your help
01 February 2016 3,374 0 View
I' m interested in construction noise, shotcrete pumps and shotcrete silos discharging
03 April 2015 2,629 2 View
I usually use SourceDB, I' d like to know if there are other industrial noise database that you trust. Thank you for your help
01 February 2015 2,279 3 View
01 February 2015 7,026 2 View
01 February 2015 2,890 0 View
02 March 2021 7,082 3 View
I'm looking at the aggregation of my protein sample using DLS. Unfortunately, my buffer (20mM HEPES) also results in a set of peaks. These are at approximately 1 and 1000 d.nm. The lowest peak...
01 March 2021 9,015 2 View
I'm looking for the human CD34 promoter sequence to engineer into a vector construct. Can anyone recommend a good source for this sequence? Thanks very much, Laura
25 February 2021 8,205 1 View
Hi all, I proceed with nucleic acid gel electrophoresis recently several times, but a wried phenomenon is they always melted after running over 30min. My gel concentration is 1% percentage...
22 February 2021 9,896 3 View
What low-cut filter (high Pass frequency) to be used for the response spectrum (Tripartite plots)? I am currently working on differentiating between hard/soft site responses in Indo-Gangetic...
21 February 2021 9,273 2 View
Hello, I'm currently running a PCA on a polytomous data set (5 point Likert). I want to create a discrimination index to narrow down my items before running the PCA. After looking around, I'm...
13 February 2021 3,517 2 View
I am doing an analysis on some FLIM data in the form of time series image stacks. I need their signal-to-noise ratio. Recording starts several picoseconds before the excitation pulse, so no sample...
08 February 2021 7,169 3 View
I want to completely delete or largely truncate a gene and not only achieve a functional knockout in a cell line. I can only transfect my cells with the Crispr/Cas9 sgRNA RNP and not introduce a...
08 February 2021 2,032 2 View
When I am trying to implement a pressure sensor through instrumentation amplifier and then giving it's output to Arduino, I am getting garbage value due to noise, so how to eliminate it.
05 February 2021 8,598 11 View
My design contains three parts. A silicon rubber membrane is placed between upper and lower part. I want to calculate sound transmission loss by using comsol Multiphysic. There are lots of...
05 February 2021 466 4 View