What is the principle of emission accounting approaches ?

e.g. absolute emissions, life cycle assessment, marginal emissions, time-varying carbon intensity, pinch analysis, Kindly explain me please one by one

11 December 2018 1,514 1 View

Could anyone tell me, how to convert CO2-equivalent emission (gram per year ) to g CO2-eq/kWh ??

Kindly send me the calculation procedure with references I got a relationship on google but i dont know either its right or wrong Using an unit convertor of 1Mt = 1.67 g/kWh (100-year energy...

05 June 2016 8,971 2 View

How to convert "ppm" to "weight % (part per hundred)" in case of Major element ?

In the XRF method to measured heavy metal in soil sample, the concentrations of the major elements (Al, Ca, Fe, K, Mg, Mn, Na, P, Si, Ti ) are reported in weight % units and the concentrations of...

01 February 2016 164 34 View

Could anyone know me detail procedure of determination of CO2, CH4 and N2O production and degradation rate in forest soil using GC-MS ?

01 February 2016 2,013 3 View

Could anyone tell me the reason when NDVI and SOC shows good fit with R2 = 0.51 and root-mean-square error (RMSE) of 2.86 ?

Regression modelling was done to create SOC map for the basin with NDVI values.

31 December 2015 9,605 8 View

Could anyone suggest me how to draw scattered plot with Lowess curve ?

Any tool or software

11 December 2015 4,385 1 View

Could anyone provide me idea about the impact/correlation of C:N:P ratio with CH4, CO2 and N2O from Reservoirs/soil/sediment ?

09 October 2014 562 4 View

Could anyone please explain to me preparation methods of Diphenylamine indicator (169.23 g/mol) with reference...???

See above.

04 May 2014 198 1 View

What are the countries most affected by extreme rainfall as a result of climate change?

Increased heat, drought and insect outbreaks, all associated to climate change, have increased wildfires. Decreasing water supplies, declined agricultural yields, health impacts in cities owing to...

01 March 2021 7,168 9 View

Timeout error!! Processor in the loop (PIL) using STM32F4 Matlab 2018a?

Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...

01 March 2021 2,327 1 View

Where to find data on trees in tropical agroforestry?

Hi, I'm looking for data (mainly related to management: growth rate, canopy size, soil and climate preferences, etc.) about tropical trees used in tropical agroforestry. Have you ever heard about...

28 February 2021 7,356 8 View

No title

I am trying to find how to know the density needed for a pva electrospinning in a 0.6mm neddle, the electrospinning will be from top to bottom and the problem I really have is the solution because...

25 February 2021 2,615 3 View

How Can I clain a removal of a co-author?

I would like to make a correction in a co-author in your paper which is wrong. This name is also in other papers of Kenton Ko. Zey Ko is not a Co-author . The correct name is Zdenka...

24 February 2021 3,476 4 View

How does the injection volume impact LLOQ and ULOQ in regression analysis (LC-MSMS)?

Hello, I have run into an issue that has sparkled a debate at work: is the LLOQ/ULOQ impacted by injection volume under the following circumstances: 1) Same dilution factor of all samples 2)...

23 February 2021 9,159 3 View

Difficulty in debugging code to correct error - TypeError: '<' not supported ?

I am trying with a Unet code ontained from net ...in tensorflow. When trying to predict the segmentation result with the trained and saved model with metric " iou" using "CustomObjectScope"...

22 February 2021 5,254 1 View

How to perform Haldane correction on SPSS?

I was wondering if anyone knew how to perform the Haldane correction for SPSS (this is the definition of the correction -...

21 February 2021 2,882 1 View

absorption= 1-mag(S(FP1:1,FP1:1)*S(FP1:1,FP1:1))-mag(S(FP2:1,FP1:1)*S(FP2:1,FP1:1)) is it correct for absorption ?

hi everyone I am simulating a unit cell structure in HFSS using Flouquet port having two modes for absorption I have used this formula:- absorption=...

17 February 2021 9,178 2 View

I have done flood mapping using sentinel 1 image but for validation i am unable to find any dataset...what dataset should i download...??

I have done flood mapping using SAR but for validation i am finding difficulty in getting a data set...i opted for LANDSAT image but there i am facing difficulty in cloud coverage as coverage is...

16 February 2021 4,620 3 View