FinFeT being the devices opted my most semiconductor manufacturing companies is it good port my MoSFETs based circuit implementation to FinFeT based?

Which is the most convenient manufacturing software for Additive Manufacturing?

Which tools can be used to generate machine codes for additive manufacturing?

02 March 2021 7,220 2 View

What element is driving the different slop in the low frequency tail?

My study consists simple corrosion inhibitors in salty brine. Right now I just fit my circuit with randles with CPE. Just wondering how the slop can given more info of the experiment. Or any...

01 March 2021 6,474 3 View

How to model the battery pack in PSIM or PSCAD?

Hello, I have simulated a single battery cell using Thevenin equivalent circuit. For a battery pack, I have a large number of cells connected in series and parallel connections. Is there any way...

28 February 2021 2,116 1 View

Does the circuit modeling for planar monopole antennas using Foster canonical forms give good approximation?

Hi researchers, I am searching for some accurate way to do the circuit modeling of planar CPW-fed monopole antennas. I have gone through the literature where mostly circuit modeling is done using...

28 February 2021 7,016 1 View

How to design a boost converter for a mppt controller?

I have a doubt on how to select the inductor and capacitor value when I want to implement MPPT controller. This is because we always take a maximum output voltage and current but in this case, we...

28 February 2021 3,637 2 View

What software programs can directly simulate Additive Manufacturing Directed Energy Deposition (DED)?

I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....

24 February 2021 4,428 3 View

PMSM Inter Turn Short Circuit fault, Dataset?

Hi, I'm looking for a dataset of a PMSM with an inter turn short circuit fault. Does anyone know a dataset which is available?

21 February 2021 5,663 2 View

Why are the modelled and circuit system different in response for controlled buck converter?

[Images are attached at bottom] I am currently working on a buck converter controlled by two different control methods, Reinforcement learning applied to find PID values & a lead-lag...

16 February 2021 5,060 10 View

How to differentiate the economic productivity in agriculture and in manufacturing sector?

Most of the references I found were on the economic productivity in agriculture but very limited application in manufacturing sector. I would appreciate if anyone could share the references on...

15 February 2021 8,342 7 View

How to derive equations for a resonant buck converter with ZVS?

I am not understanding how each author is deriving the equations and the working principle. Individual authors are giving their own working principle explanation for different circuit topology....

12 February 2021 496 1 View

Abdelhalim Zekry

If you target higher speed and greater drive ability in addition to higher integration density you can go for finfets. But you have to be sure that you could fabricate your design.

For more pros and contras please follow the link:http://www.techdesignforums.com/practice/guides/finfets/

Best wishes

R. Udaiyakumar

Thank you Professor. I am really looking for device fabrication