Except organic solvents, What is the best solvent to dissolved PMMA?

More Burak Yahya Kadem's questions See All

Why does zinc-phthalocyanine reduce Voc of the P3HT:PCBM solar cell when it is used between the PEDOT:PSS layer and the active layer?

Voc was reduced form 0.62 to 0.55. Is there any specific reason?

03 April 2015 8,822 1 View

Should I perform fluorescence measurements of organic materials rather in solution or as thin film?

In fact, I did it for both thin film and solution and I found different results with different excitation wavelength.

03 April 2014 8,643 3 View

Why do I get a drop in voltage when my current is good (and vice verse)?

This in the case of an organic solar cell and high open circuit voltage.

03 April 2014 3,742 6 View

Polymer wear calculation?

What is the method for analytically calculating the wear and service life of polymer-polymer sliding pairs?

04 August 2024 1,078 1 View

How to calculate effect size of AMCE (Average Marginal Component Effect) in Randomized Conjoint Experiment?

I am following Hainmueller, Hopkins, and Yamamoto's (2014) paper for my randomized conjoint experimental data analysis. The link to the paper is provided below. I received a comment from the...

02 August 2024 4,406 0 View

How to explain the different interaction between soluble and insoluble polymer in water?

Hello everyone, I am try to understand the differences interaction between insoluble and soluble polymers in water with metal ions and how theit charge density (of metal ions) affect the interaction.

29 July 2024 6,350 3 View

How to conduct a sensitivity power analysis for Kendall's Tau?

Is there a straightforward way to conduct a sensitivity power analysis for a Kendall's Tau correlation? I was considering using the sensitivity setting and "Correlation: point biserial model" test...

28 July 2024 6,133 8 View

Getting standard errors and T-statistics for Dynamic panel data with instrumental variable method?

Dear all, I have a user written estimation code based on the paper dynamic panel data estimations with fixed effect by Galvao(2009). I have seen many papers using this method and pvalue, standard...

22 July 2024 4,588 1 View

What is the difference between coordination polymer, MOFs, MCOFs?

Wherever I have referred, it puts me in a dilemma about the exact differences between these. It would be really helpful if someone can put me out of this trouble.

21 July 2024 3,045 3 View

Appearance of crystallization peak in heating cycle of DSC test?

For which types of polymers, the crystallization peak in heating cycle of DSC test can be observed and for which types cant? In another word, when this exothermic crystallization can be observed...

18 July 2024 348 3 View

Interpreting ATR-FTIR Spectra for Microplastics Research?

Hello everyone, I am currently pursuing a PhD in Environmental Engineering with a focus on microplastic studies. My background is in Civil Engineering, and I am relatively new to working with...

18 July 2024 7,258 3 View

How to resolve ‘[ atomtypes ] Invalid order for directive atomtypes’ error in Gromacs?

I have been using Gromacs 2021.7. I wanted to simulate two small molecules in water. But, while generating the ions.tpr, I am getting the following error. The topol.top and .itp files for each...

17 July 2024 9,897 4 View

How do you decide an optimal AC amplitude for non-faradaic electrochemical impedance spectroscopy?

I work with planar interdigitated electrodes (IDEs). The finger width and the spacing between the fingers are 5 micron. The surface of the IDEs is coated by a non-conductive polymer layer...

16 July 2024 5,031 1 View